bmw e90 rear diff
bmw e90 rear diff
Author
Discussion

ajk671

Original Poster:

15 posts

120 months

Monday 7th November 2016
quotequote all
Hi guys my e90 318i has had a noisy diff for a few month, i have been using the car while looking for a re conditioned diff , anyway the car seemingly drives fine apart from the noise, the car went into the garage today for new rear pads , however i had a call from them saying the pads are still ok but there are 2 score marks on the inside of the caliper as if the disc is rubbing on it , the garage cant give me an explanation apart from that the faulty diff is causing exessive play wich is causing this , does this right to anyone ?

thanks in addvance

andy

roofer

5,136 posts

242 months

Monday 7th November 2016
quotequote all
I would suspect wheel bearing in that instance.

Swervin_Mervin

5,013 posts

269 months

Monday 7th November 2016
quotequote all
roofer said:
I would suspect wheel bearing in that instance.
Which will also sound a bit like a noisy diff. Speaking from experience.

ajk671

Original Poster:

15 posts

120 months

Tuesday 8th November 2016
quotequote all
hi roofer thanks for the reply, when driving if i dip the clutch the noise goes and come back as soon as soon as you lift the clutch , both rear wheel bearing were replace before i was then told the noise was the diff, the garage said if the diff bearing is collapsing it is causing movement wich had caused this rubbing wich is on both calipers worse on drivers side

Swervin_Mervin

5,013 posts

269 months

Tuesday 8th November 2016
quotequote all
If it was the diff it would make a noise regardless of whether drive is engaged confused

iSore

4,011 posts

175 months

Tuesday 8th November 2016
quotequote all
A wheel bearing will make a drone that increases with speed, and will alter in pitch as you navigate roundabouts, shaper bends etc. It won't change as you throttle on/off.

A diff will make a drone that increases with speed, but will alter in pitch as you throttle on/off. Bend won't make much difference.

E90 small case diffs do get noisy with high miles - 318i and 320i cars are prone, as are the 116i, 118i and pre 2008 (M47N) 1128 diesels.

In common with the late E46, these diffs don't have a drain /fill plug so a diff seal oil leak will result in a whiney diff before long. In the good old days, draining the diff and refilling with EP140 made a whiney diff a lot better.

If the diff is shagged, forget recons but find a good used one. About £250 and a hour (90 minutes tops) on a ramp to change - they're really easy.

iSore

4,011 posts

175 months

Tuesday 8th November 2016
quotequote all
Swervin_Mervin said:
If it was the diff it would make a noise regardless of whether drive is engaged confused
Not if the pinion bearings are shagged - the most common problem.

Swervin_Mervin

5,013 posts

269 months

Tuesday 8th November 2016
quotequote all
iSore said:
Swervin_Mervin said:
If it was the diff it would make a noise regardless of whether drive is engaged confused
Not if the pinion bearings are shagged - the most common problem.
Oh right. How so? Surely everything's still spinning?

HustleRussell

26,708 posts

191 months

Tuesday 8th November 2016
quotequote all
No, A faulty diff cannot cause axial play at a brake disc. It is not possible to state definitively what your issue is here but the whoever told you that the diff is causing the disc to run on the caliper is wrong.

iSore

4,011 posts

175 months

Tuesday 8th November 2016
quotequote all
Swervin_Mervin said:
Oh right. How so? Surely everything's still spinning?
It is, but the crown wheel and pinion are not under the same load. Power on= the pinion is driving the crown wheel. Power off - the crown wheel is driving the pinion. Worn taper roller pinion bearings allow the pinion to move up and down slightly and the cwp/pinion teeth don't mesh correctly and that's what makes the whining sound. They are shimmed at the factory to that the teeth contact patches are correctly aligned - to prevent gear noise. A worn diff will howl along for a very long time as long as there is oil.

With regard to the marks on the calliper/carrier - sounds like there is (or was) massive play in the rear wheel bearing, allowing the disc to 'machine' marks into the caliper. Check that the rear hub nuts are fully tightened!

Swervin_Mervin

5,013 posts

269 months

Tuesday 8th November 2016
quotequote all
iSore said:
Swervin_Mervin said:
Oh right. How so? Surely everything's still spinning?
It is, but the crown wheel and pinion are not under the same load. Power on= the pinion is driving the crown wheel. Power off - the crown wheel is driving the pinion. Worn taper roller pinion bearings allow the pinion to move up and down slightly and the cwp/pinion teeth don't mesh correctly and that's what makes the whining sound. They are shimmed at the factory to that the teeth contact patches are correctly aligned - to prevent gear noise. A worn diff will howl along for a very long time as long as there is oil.
Thank you thumbup That's today's new thing learnt smile

ajk671

Original Poster:

15 posts

120 months

Tuesday 8th November 2016
quotequote all
thanks for all the input guys, the noise doesnt change when cornering etc, only when you come off the throttle it really howls, is the pinion crown part of the diff? , been looking at second hand ones but not sure what ratio i will need also they could have the same problem, surely i would get some warrnty on a reconditioned one? , as for the brakes i just couldnt get my head round the fact he was saying the diff was causing things to move , he said maybe the discs were too big ? all round the outside of the discs are rusty and not shiney which you would think if they were still rubbibg the inside top of the caliper, would it be likely the hub nuts to loosen on both sides and would that not cause some kind of vibration or wobble at speed as the car runs fine , no judder as if anything is rubbing like you would get with binding breaks ?

iSore

4,011 posts

175 months

Tuesday 8th November 2016
quotequote all
It does sound like a shagged diff - the crown wheel is the big circular gear driven by the pinion. Your garage sound like they may have trouble differentiating between arse/elbow. Ratios? 318i's are a 3.23, same diff as 116i and 118i. 320i's have a 3.38 ratio small case but one of these will bolt straight in.

roofer

5,136 posts

242 months

Tuesday 8th November 2016
quotequote all
HustleRussell said:
No, A faulty diff cannot cause axial play at a brake disc. It is not possible to state definitively what your issue is here but the whoever told you that the diff is causing the disc to run on the caliper is wrong.
This.

ajk671

Original Poster:

15 posts

120 months

Tuesday 8th November 2016
quotequote all
so is the crown wheel and pinion inside the diff ?

helix402

7,913 posts

213 months

Tuesday 8th November 2016
quotequote all
Yes.

iSore

4,011 posts

175 months

Tuesday 8th November 2016
quotequote all


2 is the crown wheel, 7 is the pinion.

ajk671

Original Poster:

15 posts

120 months

Tuesday 8th November 2016
quotequote all
thanks , il start looking for second one i think

HustleRussell

26,708 posts

191 months

Tuesday 8th November 2016
quotequote all
ajk671 said:
the noise doesnt change when cornering etc, only when you come off the throttle it really howls, is the pinion crown part of the diff?
That does sound like gear noise, more specifically excessive crownwheel / pinion backlash. The diff was built poorly, run without oil or it has done many, many more miles than you think it has.

Your brakes issue is separate.

roofer

5,136 posts

242 months

Tuesday 8th November 2016
quotequote all
HustleRussell said:
That does sound like gear noise, more specifically excessive crownwheel / pinion backlash. The diff was built poorly, run without oil or it has done many, many more miles than you think it has.

Your brakes issue is separate.
A dipping clutch would indicate layshaft Bearing to me...