ABS light, car won't start after changing wheels
ABS light, car won't start after changing wheels
Author
Discussion

here_we_go

Original Poster:

178 posts

137 months

Sunday 20th November 2016
quotequote all
Drove over to my brother's house to put my winter tyres and wheels on my E61 (he has more storage than me!).

Wheels all swapped over fine (or so I thought) but when I try to start the car, ABS light comes on and car won't start.

Anyone seen this before? Or have any thoughts on what this might be? Can't think it's anything serious - car has been perfectly fine - so we've either unwittingly done something or we need to persuade the car it's okay.

anonymous-user

85 months

Sunday 20th November 2016
quotequote all
Could see the ABS light coming on if you've damaged a wheel sensor somehow but not sure why it wouldn't start. Our Z4 had a failed ABS module, still ran, just with warning.

mark.c

1,090 posts

211 months

Sunday 20th November 2016
quotequote all
When you say won't start, does it turn over at a normal pace?

If not, you may have just drained the battery with the doors open etc whilst changing the wheels? A low battery can throw up all manner of lights and fault codes.

Blaster72

12,719 posts

228 months

Sunday 20th November 2016
quotequote all
+1 for the battery too.

Check the usual suspects, flat battery, no fuel, brother being a dick and disconnected something for a laugh etc...

Huff

3,448 posts

222 months

Sunday 20th November 2016
quotequote all
Come to that, just check how tight the terminals post clamps on the bettery are - I once had my e39 throw all the symptoms of a flat battery, to teh extent it would not jump-start (click-click-click, no fire) - until I dug out a multimeter and checked it. Nope, battery terminal post voltage OK! but measured across terminal clamps - not OK!

The problem is the way they use a T-shaped nut to draw together the two halves of the clamp on the underside - it is awful, leaves the thing free to loosen slightly in their own time. Tap the clamps down on the post taper with, say, a small hide mallet (or the butt end of a hammer handle), tighten a smidge with the 10mm spanner and try again.

In fact can I suggest you do this anyway, even if it isn't the cause.