E60 RPA stuck on 'initialising'
Discussion
hi, some advice would be appreciated.....
BMW E60 545i - tyres are Yokohoma Run Flats. Puncture warning light came on this morning. Checked pressure on all tyres and front o/s was low. Inflated back to 2.1 bar, equalised all 4 corners and re-set via I-drive. I know that the initialising can take some time to sort itself out and become active, but nothing is happening. The system seems to be stuck in 'initialising' and I have driven for over 30 minutes. Tried resetting a few times but the same thing happens. I'll check pressures manually again tomorrow in case I have a slow puncture, but does anyone have any suggestions as to why the RPA will not become active? Thanks in advance....
BMW E60 545i - tyres are Yokohoma Run Flats. Puncture warning light came on this morning. Checked pressure on all tyres and front o/s was low. Inflated back to 2.1 bar, equalised all 4 corners and re-set via I-drive. I know that the initialising can take some time to sort itself out and become active, but nothing is happening. The system seems to be stuck in 'initialising' and I have driven for over 30 minutes. Tried resetting a few times but the same thing happens. I'll check pressures manually again tomorrow in case I have a slow puncture, but does anyone have any suggestions as to why the RPA will not become active? Thanks in advance....
Gassing Station | BMW General | Top of Page | What's New | My Stuff


