E39 rear brake lines
E39 rear brake lines
Author
Discussion

lufbramatt

Original Poster:

5,695 posts

165 months

Monday 19th December 2016
quotequote all
After spending the summer welding up the floors of my E39 I'm finally ready to start putting it back together.

The previous owner had the rear brake pipes replaced due to rust, however I'm not happy with the way it was done (badly routed around the tank and used copper rather than cunifer) so seeing as I have the kit I might as well redo the job while the fuel tank is off the car.

Does anyone have any images of the correct route over the tank and rear axle? I don't have the original pipes for reference just these horrible snaky copper things with loads of twists and turns in.

Also the fittings appear to be M10x1 male with a single DIN flare the same as other german cars I've worked on, except where the rear pipes meet a joining piece under the drivers footwell, on one side this fitting appears to be M12x1. Does that sound correct?