E91 front brake pad change...DIY job?
Discussion
Quick one...my 2008 E91 is saying it needs new front pads. I am a competent spannerer...is this a DIY job? I have no problems with the mechanical aspect, however will the computer need resetting in some way to clear the warnings on the iDrive? I have a basic OBD2 generic code reader/clearer however I don't know if the BMW needs specific equipment here. I was told even a battery swap needs to be done by a dealer for this reason...
Thanks in advance...
Thanks in advance...
Hard-Drive said:
Quick one...my 2008 E91 is saying it needs new front pads. I am a competent spannerer...is this a DIY job? I have no problems with the mechanical aspect, however will the computer need resetting in some way to clear the warnings on the iDrive? I have a basic OBD2 generic code reader/clearer however I don't know if the BMW needs specific equipment here. I was told even a battery swap needs to be done by a dealer for this reason...
Thanks in advance...
Should be straightforward as long as you fit a new wear sensor - IIRC the pad indicator can be reset from iDrive. Thanks in advance...
As for batteries, it depends. If you fit an identical replacement you're fine - if you change the capacity then it has to be registered so the correct charging profile is used.
Changing the pads is easy as already said. Before doing that I would check that new pads are really needed because those sensors can be too careful. I have 8mm to 9mm on the pads on my F30 but the service indicator shows that a change is due in 4k miles, they will last much longer than that!
Gassing Station | BMW General | Top of Page | What's New | My Stuff


