Heated grips fitting
Author
Discussion

A500leroy

Original Poster:

8,623 posts

149 months

Saturday 1st April 2017
quotequote all
Any tips guys, I'm concerned about doing the wiring well enough to not cause issues turning the bars.

Wedg1e

27,048 posts

296 months

Saturday 1st April 2017
quotequote all
Follow the route the existing wiring loom takes and there shouldn't be a problem (as long as your cabling isn't as tight as guitar strings).

mudster

792 posts

275 months

Saturday 1st April 2017
quotequote all
Would recommend wiring through a relay on an ignition controlled live. Avoids flattening the battery if you forget to switch off the grips when you switch off the engine.

4 or 5 pin relay, relay holder required. Interweb has plenty of guides how to wire up relays.

darkyoung1000

2,497 posts

227 months

Saturday 1st April 2017
quotequote all
For putting the actual grips themselves on the bars, hairspray is really useful.
When wet, it acts as a lubricant to slide them on, then keeps them there when it dries and goes tacky.
Cheers,
Tom

Rubin215

4,201 posts

187 months

Sunday 2nd April 2017
quotequote all
If the battery is under the seat, I usually put a relay in the circuit and take a feed from the rear brake light circuit as a switched live to trigger it and then fasten the wiring to the existing loom using thin cable ties

For fitting the grips on the bars I clean off the old glue with brake cleaners then use a carpet-fitter's spray adhesive to give the inside of the grip and the bar a light coating.

In terms of grip choice, I think Oxford give the best reliability and heat for the price.

heyhomes

118 posts

157 months

Sunday 2nd April 2017
quotequote all