Small Business WiFi - Ubiquiti UniFi or something else?
Discussion
anonymous said:
[redacted]
Yes, but you would need to migrate the devices from one controller to the new one, which can be a PITA.Doing it from your laptop is a little Home User
I have used an Azure server that gets spun up and down when changes need to be made to it, but other solutions are available, i.e. one of their little controller devices for an extra hundred, or an old desktop running Linux hiding in a cupboard. With just APs, dont worry about it unduly, but adding things like the USG and potentially VoIP phones into the mix, its better being up, so you can quickly interact with it.randlemarcus said:
Yes, but you would need to migrate the devices from one controller to the new one, which can be a PITA.
Doing it from your laptop is a little Home User
I have used an Azure server that gets spun up and down when changes need to be made to it, but other solutions are available, i.e. one of their little controller devices for an extra hundred, or an old desktop running Linux hiding in a cupboard. With just APs, dont worry about it unduly, but adding things like the USG and potentially VoIP phones into the mix, its better being up, so you can quickly interact with it.
Why pay out for an Azure server. Just create a VM and keep it shutdown until needed. You can then have a backup copy of the VM too.Doing it from your laptop is a little Home User
I have used an Azure server that gets spun up and down when changes need to be made to it, but other solutions are available, i.e. one of their little controller devices for an extra hundred, or an old desktop running Linux hiding in a cupboard. With just APs, dont worry about it unduly, but adding things like the USG and potentially VoIP phones into the mix, its better being up, so you can quickly interact with it.I'm a Ubiquiti convert. Friend of mine had been waxing lyrical about it for some time, and I had managed to ignore him.
Moved to new offices and decided the existing overly complicated Cisco WiFi setup that was in situ wasn't going to provide enough coverage, so just bought a load of ceiling mounted UAP-Pros.
Wired them all up (PoE made it a breeze), had everything up and running in minutes and everyone can walk around the entire building and seamlessly move from one AP to another. Even got it working with a tenant and guests with the minimum of fuss (it natively supports VLANs and guest portals).
Basically - they're brilliant. Once you've tried them you'll wonder why you used anything else.
Moved to new offices and decided the existing overly complicated Cisco WiFi setup that was in situ wasn't going to provide enough coverage, so just bought a load of ceiling mounted UAP-Pros.
Wired them all up (PoE made it a breeze), had everything up and running in minutes and everyone can walk around the entire building and seamlessly move from one AP to another. Even got it working with a tenant and guests with the minimum of fuss (it natively supports VLANs and guest portals).
Basically - they're brilliant. Once you've tried them you'll wonder why you used anything else.
HantsRat said:
Why pay out for an Azure server. Just create a VM and keep it shutdown until needed. You can then have a backup copy of the VM too.
In that instance, mostly because it was for a global rollout, where the enterprise existed solely in Azure, so there was no Datacentre in the middle, and the config was being done by me, from my study. Azure was a nice easy place to put the controller, with roughly good access for the adoption process, and not too tricky for the nice delivery folks to troubleshoot on physical installation.anonymous said:
[redacted]
You can adopt the AP on another controller using SSH, bit tecchie but not impossible by any stretch of the imagination.Just lob a PC in the corner and install the controller on it in service mode, job done.
Token based guest access is very handy as you can give out time limited passes to visitors.
I would point more towards the AC-Lite rather than Pro. But you would be better off with more standard APs sensibly placed than a couple of AP-Pros - Ideally one AP per 20 people (most people have phone/laptop etc).
The setup is very straight forward - with only a little more effort required if everything is not on the same LAN.
Make sure you set up a corporate and guest access.
Typically for a new site I set up the following basic networks:
- Two SSIDs and groups should be configured:
Guest
Corp
- For Guest the following policy should be used:
Guest Control:
* Enable Guest Portal
* Simple Password
* Enable Portal Customization - A disclaimer can be edited to suit
* Restricted subnet should include in addition to RFC1918 your internal networks
For User Group 'Guest' (configure as suitable - note this is PER Client, not total for all clients).
* Bandwidth Limit Down = 2000Kb
* Bandwidth Limit Up = 500Kb
For Wireless Network Guest
* SSID = Guest
* Security = WPA-Personal
* Security Key
* Enable Guest Poilcy
* User Group 'Guest'
For Wireless Network Corp
* SSID = Corp
* Security = WPA-Personal
* User Group 'Corp'
For User Group 'Corp-Users'
* Bandwidth Limit Down = 5000Kb
* Bandwidth Limit Up = 2000Kb
The setup is very straight forward - with only a little more effort required if everything is not on the same LAN.
Make sure you set up a corporate and guest access.
Typically for a new site I set up the following basic networks:
- Two SSIDs and groups should be configured:
Guest
Corp
- For Guest the following policy should be used:
Guest Control:
* Enable Guest Portal
* Simple Password
* Enable Portal Customization - A disclaimer can be edited to suit
* Restricted subnet should include in addition to RFC1918 your internal networks
For User Group 'Guest' (configure as suitable - note this is PER Client, not total for all clients).
* Bandwidth Limit Down = 2000Kb
* Bandwidth Limit Up = 500Kb
For Wireless Network Guest
* SSID = Guest
* Security = WPA-Personal
* Security Key
* Enable Guest Poilcy
* User Group 'Guest'
For Wireless Network Corp
* SSID = Corp
* Security = WPA-Personal
* User Group 'Corp'
For User Group 'Corp-Users'
* Bandwidth Limit Down = 5000Kb
* Bandwidth Limit Up = 2000Kb
anonymous said:
[redacted]
Bit late on the reply, but I presume he refers to the AC-Lite as the 'standard' access point.Any yes, my understanding is you want a cloudkey for £70, as a home user with just two AC-Lites planned I am planning to avoid this but for anything else you just go with the spend. A switch from Pro to Lite will save the cost and more anyway!
IF you have the system up and running now, how is it doing?
Daniel
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff



