Bugger. Broke my clutch switch. Question...
Discussion
As above, fitted my RCS19 and matching clutch lever on my 2015 R1 and managed to snap the pillar off the clutch switch when fitting the clutch lever (I know, I'm a knobhead).
Consequently the bike thinks the clutch is permanently in. Will there be any detrimental effects to riding the bike until I replace it? I'll obviously need to make sure it's in neutral before starting it but does the switch do anything other than that? The only reason I ask is the bike was reluctant to start and idle and ran rough as nails when I ran it round the block. It's most likely just because I threw a load of water at the bike (just in case I'd unknowingly spilt any brake fluid when bleeding the m/c) and I probably got some water in a switch or sensor somewhere.
Thanks
Dave
Consequently the bike thinks the clutch is permanently in. Will there be any detrimental effects to riding the bike until I replace it? I'll obviously need to make sure it's in neutral before starting it but does the switch do anything other than that? The only reason I ask is the bike was reluctant to start and idle and ran rough as nails when I ran it round the block. It's most likely just because I threw a load of water at the bike (just in case I'd unknowingly spilt any brake fluid when bleeding the m/c) and I probably got some water in a switch or sensor somewhere.
Thanks
Dave
Thanks. It actually starts in gear as the switch is a simple pillar switch; the pillar is pushed in when the clutch is out so now that I've snapped the pillar off, the bike essentially thinks the clutch is in all the time so I'll have to be careful not to start it in gear on the side stand as it'll fall over! There are no error codes so hopefully that's all the switch does 

Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


