Need to take a brave pill..
Need to take a brave pill..
Author
Discussion

A500leroy

Original Poster:

8,623 posts

149 months

Saturday 6th May 2017
quotequote all
I've had a puncture repaired on the bike, first i hope it holds ( it's dead centre of the tyre so should be ok)

Then i reassembled myself, i think I've got the calliper in the correct place it's on the same bolt that holds the rear wheel in so i cant be far wrong ( I've had a play on the yard and i can pull away with the rear brake full on so I'm a little scared I've done something wrong)

I've got the chain back on with 30mm of play and 3 markers on either side of the swing arm so I'm fairly certain it's aligned correctly, although being my first time doing anything like this with a bike i guess its all down to a slow test ride tomorrow to see if it ' feels ' correct to.

Anyone see any glaring errors or am i just being g an overcautious numpty?

R1 Dave

7,158 posts

294 months

Saturday 6th May 2017
quotequote all
Would be easier to assist if you posted some photos or said what bike it was?

You shouldn't need to touch the alignment adjusters to remove the wheel.

A500leroy

Original Poster:

8,623 posts

149 months

Saturday 6th May 2017
quotequote all


Honda cbr

R1 Dave

7,158 posts

294 months

Saturday 6th May 2017
quotequote all
There's also a photo of the calliper on your album - if that's today then it looks about right. It looks like such a simple setup that I'm not sure how you'd go about assembling it incorrectly! Have you tried pumping the rear brake to reseat the pads?

A500leroy

Original Poster:

8,623 posts

149 months

Saturday 6th May 2017
quotequote all
I'm guessing it has now it's been used!
That's today photo of the caliper, There's one hole to hold it on so like you say i cant have got it wrong!

A500leroy

Original Poster:

8,623 posts

149 months

Sunday 7th May 2017
quotequote all
Rides in a straight line, stops in a straight line, there's a new transmission type noise when going down hill that sounds like it's coming from the front sprocket and wierdly the front doesn't turn in as confidentiality as it did before so I'm playing around with tyre pressures.