Bbird master cylinder with 1 or 2 calipers
Discussion
Evening,
Whilst waiting for my new caliper to arrive I ran the bike with one caliper instead of two.
Yamaha diversion 900 twin piston sliding calipers.
Whilst they have always worked well the lever always had a lot of movement before it started to bite.
With only one caliper the lever was rock hard with limited movement, back to two and it has the same excessive movement.
Why ?
There is nothing untoward with the cylinder or calipers.
The bbird runs two calipers presumably with a good feel, why doesn't it work on the Yamaha ones ?
Thanka
Whilst waiting for my new caliper to arrive I ran the bike with one caliper instead of two.
Yamaha diversion 900 twin piston sliding calipers.
Whilst they have always worked well the lever always had a lot of movement before it started to bite.
With only one caliper the lever was rock hard with limited movement, back to two and it has the same excessive movement.
Why ?
There is nothing untoward with the cylinder or calipers.
The bbird runs two calipers presumably with a good feel, why doesn't it work on the Yamaha ones ?
Thanka
The master cylinder was specced to move enough fluid to operate two calipers. If only one caliper is connected, the m/c has to travel only half the distance, hence it feels "hard".
If you used a m/c from a single disc bike to operate two calipers you'd see the opposite effect. The lever would have to travel twice as far in order to move enough fluid to operate the two calipers.
Generally speaking, if the master cylinder piston diameter is too big, the brake is hard and lacks feel, if it's too small there's lots of feel, but the lever may come back to the 'bars.
If you used a m/c from a single disc bike to operate two calipers you'd see the opposite effect. The lever would have to travel twice as far in order to move enough fluid to operate the two calipers.
Generally speaking, if the master cylinder piston diameter is too big, the brake is hard and lacks feel, if it's too small there's lots of feel, but the lever may come back to the 'bars.
gareth_r said:
The master cylinder was specced to move enough fluid to operate two calipers. If only one caliper is connected, the m/c has to travel only half the distance, hence it feels "hard".
If you used a m/c from a single disc bike to operate two calipers you'd see the opposite effect. The lever would have to travel twice as far in order to move enough fluid to operate the two calipers.
Generally speaking, if the master cylinder piston diameter is too big, the brake is hard and lacks feel, if it's too small there's lots of feel, but the lever may come back to the 'bars.
Makes sense.If you used a m/c from a single disc bike to operate two calipers you'd see the opposite effect. The lever would have to travel twice as far in order to move enough fluid to operate the two calipers.
Generally speaking, if the master cylinder piston diameter is too big, the brake is hard and lacks feel, if it's too small there's lots of feel, but the lever may come back to the 'bars.
thanks
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


