93 zxr750 leaving fuel petcock turned on?
93 zxr750 leaving fuel petcock turned on?
Author
Discussion

robbocop33

Original Poster:

1,207 posts

138 months

Thursday 15th June 2017
quotequote all
Bugger, restoring this bike and had it sitting for a while, tried to start it but it was like it was flooded(new plugs, oil etc last week) , eventually it 'sort of' tried to run, but just died when giving it throttle.
Had a quick look on line and first thing i spotted was people saying not to leave the petcock on? Sure as hell, looked at oil level glass and it had shot up, petrol contaminating the new oil i just put in! Damnit!
Is it a good habit to turn fuel off all the time if it's to be sitting overnight/for a while? Can't remember having this problem with my 92 Blade? I've dumped oil and drained carbs, just wish i had twigged quicker and not tried to keep it running, knowing now fuel was in oil.

graham22

3,328 posts

236 months

Thursday 15th June 2017
quotequote all
I think the early 'blades had a fuel pump, hence not flooding with ignition off. Later (carb) blades didn't have a pump. (I think I got this right, had a 93 & 98 and I'm sure I felt this difference was unusual).

Always good idea to turn fuel off, especially when bike only has side stand - have heard stories of hydraulic lock on left and cylinders in the past.

J50NWA

304 posts

168 months

Thursday 15th June 2017
quotequote all
my zx9r had the same problem, its the weight of the fuel pushes through the fuel pump and float bowls then into the cylinders and crankcase. Shouldn't happen, but does. New float pin seals and good adjustment should cure, but for the cost of oil and filter, I'd get used to switching the tap.

podman

9,087 posts

271 months

Thursday 15th June 2017
quotequote all
I think your tap should be a vacuum one (does it have on/res(erve) and Pri(ime) options?

If so the diaphragm has most likely failed within it, they are not difficult to rebuild...then of course its just a case of sorting the carbs but of the tap is working as it should, it shouldnt cause a problem further down the line anyway.

Tom Logan

3,872 posts

156 months

Thursday 15th June 2017
quotequote all

Beware of hydraulic lock and bent con rods if the c/case fills with fuel, I lost a TZ crank because of a fuel tap passing when in the off position, especially with a bike that has an electric boot, you could easily wreck the whole motor.

robbocop33

Original Poster:

1,207 posts

138 months

Thursday 15th June 2017
quotequote all
podman said:
I think your tap should be a vacuum one (does it have on/res(erve) and Pri(ime) options?

If so the diaphragm has most likely failed within it, they are not difficult to rebuild...then of course its just a case of sorting the carbs but of the tap is working as it should, it shouldnt cause a problem further down the line anyway.
Mine's just has on,off and reserve.Just a quick background,bought bike,guy was good enough to put a thimbleful of fuel in it to let me hear it run,i then put fuel in it,put tap from reserve to on,it started fine after that,second time I started it after having fuel tap on all the time for two weeks it's now like this.
I'll just start putting it to off to be safe.