1979 bonneville rockers help
1979 bonneville rockers help
Author
Discussion

crofty1984

Original Poster:

17,064 posts

235 months

Sunday 2nd July 2017
quotequote all
I think I've made a mistake. A bad mistake.
I was adjusting my tappet clearances and changing the tappet adjuster screws while I was at it for some allen head ones to make future jobs a bit easier. Ironic I know.
The inlet rocker now does not move at all if you turn the engine over, regardless of where the adjuster is. But moves up and down very freely to the extremes of travel.

This is my theory, I'd appreciate any advice/comments.

I got the valve to the right position. Right inlet fully open, so I'm working on the left inlet.
Took the tappet screw out to put the new one in.
The new one can screw all the way "in" without coming up against any kind of stop, as in it will touch the top of the valve and start, just pushing the rocker further up.

I'm assuming that while changing the adjuster screw I must have I moved the rocker arm to one extreme or the other, and whatever connects the top of the pushrod to the rocker arm has fallen out.

Does that seem likely or are there other explanations?

If so, can I fix it by just taking the rocker cover off, or is it an engine out job?

Yours in stupidity and frustration,
Dan

crofty1984

Original Poster:

17,064 posts

235 months

Sunday 2nd July 2017
quotequote all
Found it. The pushrod came off at the bottom. Lots of flicking and manouououeeouvreing later (with the rocker box partly off) sorted it. Though I did have to do it 3 times. I imagine the rocker box base will leak now, but I'm going to have the engine out at some point I reckon so I'll put a copper gasket on it then.

Turn7

25,786 posts

252 months

Sunday 2nd July 2017
quotequote all
PITA getting the rockers hooked into the pushrods on these.