Acceptable Mods for Z4 Coupe 3.0si
Discussion
It already has the stubby aerial conversion
I am considering (very) light tinting of the rear window and rear sides but not as convinced I want to do this as I was befor.
I am going to steer clear of spoilers for now.
wondering more along the lines of M Sill plates and minor bits like that
I am considering (very) light tinting of the rear window and rear sides but not as convinced I want to do this as I was befor.
I am going to steer clear of spoilers for now.
wondering more along the lines of M Sill plates and minor bits like that
LED lights for interior, number plate and sidelights can be done for about £5 all in. New wheel caps off eBay cost about the same for a decent set and the aerial can be removed entirely for the cost of a 30 pence grommet to smooth the back end. The front grille can look very smart if sprayed matte black but that isn't to everyone's taste.
Other mods that are must do in my opinion are to put non run-flat tyres on the car and polybush or at least Meyle HD as much of the suspension as possible to improve the handling/tramlining.
Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
Other mods that are must do in my opinion are to put non run-flat tyres on the car and polybush or at least Meyle HD as much of the suspension as possible to improve the handling/tramlining.
Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
AquaMatt said:
Other mods that are must do in my opinion are to put non run-flat tyres on the car and polybush or at least Meyle HD as much of the suspension as possible to improve the handling/tramlining.
Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
Z4Ms never had Run-flat tyres - that may be why so many non-M Z4 owners swap to non-RFTs! Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
AFAIK my 3.0Si Z4C still has the CDV, but it does have a ZHP knob!
If you want more insight OP you could do worse than to head to Z4Forum......!
Mr Tidy said:
AquaMatt said:
Other mods that are must do in my opinion are to put non run-flat tyres on the car and polybush or at least Meyle HD as much of the suspension as possible to improve the handling/tramlining.
Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
Z4Ms never had Run-flat tyres - that may be why so many non-M Z4 owners swap to non-RFTs! Finally, removing the clutch delay valve and installing a ZHP gear knob are worth the money.
Any more than that and things get expensive but it depends what your aims are.
Fantastic cars, have fun!
AFAIK my 3.0Si Z4C still has the CDV, but it does have a ZHP knob!
If you want more insight OP you could do worse than to head to Z4Forum......!
Wills2 said:
For me as they get older they look better stock, but ETTO.
I'm with you on that .. stubby/zhp ok Certainly for future values I think you need to keep as original as possible.. as with all cars it becomes the original stock ones that hold their value and become the most sought after
Remove one of the foam baffles from the tube that goes from the airbox to the cabin - more induction noise.
ZHP gearknob is a great mod. Front lower wishbone bushes/lollipops if they've not been done already. Decent tyres as mentioned.
The front splitter from a Cupra R looks good IMO, not done it to ours yet
ZHP gearknob is a great mod. Front lower wishbone bushes/lollipops if they've not been done already. Decent tyres as mentioned.
The front splitter from a Cupra R looks good IMO, not done it to ours yet
Gassing Station | BMW General | Top of Page | What's New | My Stuff