3000S - access to wiring behind dashboard ?
Discussion
For my M I follow the following procedure; don't know if it is the same as an S but might be some use
Remove radio,
remove heater pipes from "bulls eyes"
Remove heater controls (mine are permenantly removed)
Remove 4 nut/bolts 2 centre rear, into bulkhead, 2 in corners in door jams
Remove steering wheel from boss (or boss from column)
Then it might, if you are lucky, tilt forward allowing reasonably good access to the rear. I recall I extended some of the wires to facilitate this.
I would fancy putting a multi conenctor on the loom so the whole thing can be removed from the car easily, but the oil pressure pipe stops this. Does anyone know of a solution??
Remove radio,
remove heater pipes from "bulls eyes"
Remove heater controls (mine are permenantly removed)
Remove 4 nut/bolts 2 centre rear, into bulkhead, 2 in corners in door jams
Remove steering wheel from boss (or boss from column)
Then it might, if you are lucky, tilt forward allowing reasonably good access to the rear. I recall I extended some of the wires to facilitate this.
I would fancy putting a multi conenctor on the loom so the whole thing can be removed from the car easily, but the oil pressure pipe stops this. Does anyone know of a solution??
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff