PCM satnav a few miles out!
PCM satnav a few miles out!
Author
Discussion

Adam B

Original Poster:

29,703 posts

283 months

Wednesday 16th August 2017
quotequote all
anyone had this? Is there a ctrl + alt + delete type reset solution?

Satnav works fine when programming but the satellite must have taken a knock as my car is currently in the middle of the Thames whilst parked outside my house - this make using the map rather tricky.

It's an 08 turbo with PCM2.1 with a non-OEM disc which worked fine up until a week ago, then the world moved on its axis by a mile odd

Any suggestions ?

anonymous-user

83 months

Wednesday 16th August 2017
quotequote all
Could be interference, suggest you check your location using the gps in your phone see if it is the same. If the same then interference is likely, if not them something might be broken.

Adam B

Original Poster:

29,703 posts

283 months

Wednesday 16th August 2017
quotequote all
phone is fine, its the PCM or the disc

hoping the latter or I need to reset something

thirdstage

34 posts

145 months

Thursday 17th August 2017
quotequote all
When this happens press the map button again and all should be sorted

Glasgowrob

3,345 posts

150 months

Thursday 17th August 2017
quotequote all
Had this many years ago on a vectra C

Ended up it was the receiver for the
Gps was faulty

997JG

46 posts

210 months

Thursday 17th August 2017
quotequote all
Probably caused by multi-path errors - if you Google it, there are detailed explainations

lingus75

1,705 posts

251 months

Thursday 17th August 2017
quotequote all
This is what happened on my 2.1 pcm a few years ago. It happened after windscreen was replaced and the antenna needed replacing as was damaged during screen fitting.

Take the plastic scuttle panels off (I can do it so must be easy!) and check the plug into antenna on the near side. It may be loose?

Adam B

Original Poster:

29,703 posts

283 months

Thursday 17th August 2017
quotequote all
lingus75 said:
This is what happened on my 2.1 pcm a few years ago. It happened after windscreen was replaced and the antenna needed replacing as was damaged during screen fitting.

Take the plastic scuttle panels off (I can do it so must be easy!) and check the plug into antenna on the near side. It may be loose?
how do you remove the panel, is the plug obvious? (no recent windscreen change btw)

Adam B

Original Poster:

29,703 posts

283 months

Thursday 17th August 2017
quotequote all
thirdstage said:
When this happens press the map button again and all should be sorted
will certainly give that a go, hopes are not high wink

ETA - well that didn't work - pressing MAP just flips map on and off and does not solve the issue

Edited by Adam B on Monday 21st August 10:32

nomank

245 posts

224 months

Thursday 17th August 2017
quotequote all
This happened to my 958 Cayenne. They checked the windscreen, wiring, aerial, etc. but still issues. In the end they replaced the unit which sorted the issue. Thankfully under warranty as would otherwise have been "around £2k" according to the dealer...

Glassman

24,930 posts

244 months

Thursday 17th August 2017
quotequote all
Adam B said:
how do you remove the panel, is the plug obvious? (no recent windscreen change btw)
Give me a call and I'll talk you through it.

lingus75

1,705 posts

251 months

Thursday 17th August 2017
quotequote all
Glassman said:
Give me a call and I'll talk you through it.
Much better for the professional to guide you than me!

Pope

2,653 posts

276 months

Thursday 17th August 2017
quotequote all
Reset a PCM 2.1 by pressing 1, 4 & 8 simultaneously.

You can check the satellite reception without getting your hands dirty; check the 'status' in the Navigation menu; it will show current location; no. of satellites etc.

The calibration can cumulatively go out of sync - have you had tyres replaced on the car recently?? On earlier versions there was a reset menu specifically for tyre change..... not sure if 2.x had it (certainly there on PCM 1)

Adam B

Original Poster:

29,703 posts

283 months

Monday 21st August 2017
quotequote all
Pope said:
Reset a PCM 2.1 by pressing 1, 4 & 8 simultaneously.

You can check the satellite reception without getting your hands dirty; check the 'status' in the Navigation menu; it will show current location; no. of satellites etc.

The calibration can cumulatively go out of sync - have you had tyres replaced on the car recently?? On earlier versions there was a reset menu specifically for tyre change..... not sure if 2.x had it (certainly there on PCM 1)
thanks

no tyre change, but had a recent detailing which may have included rain X or similar on windscreen - might that interfere with antenna?