Cheap but functional heated grips and gear indicator
Cheap but functional heated grips and gear indicator
Author
Discussion

jamiebae

Original Poster:

6,245 posts

242 months

Saturday 26th August 2017
quotequote all
I'm looking for both of the above, and possibly some hand guards too. Does anyone have some recommendations or advice of what to avoid?

Thanks

wilbo83

1,552 posts

196 months

Saturday 26th August 2017
quotequote all
jamiebae said:
I'm looking for both of the above, and possibly some hand guards too. Does anyone have some recommendations or advice of what to avoid?

Thanks
Not sure what you define as cheap but the Oxford heated grips are excellent, probably one of the only things they make that I would recommend. I have a gear indicator on mine that was fitted by the previous owner, its just a cheap ebay one but does the job, its a very simple mechanism using magnets.

Jazoli

9,707 posts

281 months

Saturday 26th August 2017
quotequote all
Oxford heated grips are bloody hot, I have some on my Versys and they are great.

I also used R&G ones on previous bikes, they are also ok but not as hot (in my experience)

you can buy cheap gear indicators off ebay for £15 but they require a lot of messing around, better ones are around £50 that are plug and play (usually into the diagnostics plug)

Globs

13,847 posts

262 months

Saturday 26th August 2017
quotequote all
Go for the V8 oxford controllers on Oxford grips IME.

jamiebae

Original Poster:

6,245 posts

242 months

Saturday 26th August 2017
quotequote all
Thanks, I'm just about to order the Oxford grips. I need to go for the 692 which are listed as the 'Sportsbike' version as the Adventure ones are too long even with the maximum chopped off which I assume will be fine as the closest my bike gets to actual adventure is hopping up a curb to park on the pavement.

I will hold fire on the gear indicator I think, if I decide I need one then I'll go for the diagnostic port version rather than having to route cables down to the shifter.

coyotev8

19 posts

111 months

Saturday 26th August 2017
quotequote all
I use Oxford heated grips touring. Cheapest place I found them was with an Oxford dealer in Poland on eBay. Very easy to install, the hardest part is choosing an appropriate path to route the wires to the battery.

It has an intelligent controller than will sense when the bike is off and cut battery draw.

Nath911t

683 posts

228 months

Sunday 27th August 2017
quotequote all
I've had both Oxford and R&G and both were fine.
If i were to get another set it would be the Oxfords as don't they turn themselves off unless you relay wire them to stop the power when the ignition is off?

terry tibbs

2,423 posts

252 months

Monday 28th August 2017
quotequote all
the glue on the LHS won't work/stick so the grip will just spin even on hot days the glue comes unstuck

other than that they're fine

jamiebae

Original Poster:

6,245 posts

242 months

Monday 28th August 2017
quotequote all
terry tibbs said:
the glue on the LHS won't work/stick so the grip will just spin even on hot days the glue comes unstuck

other than that they're fine
I've actually looked at a couple of bikes where the grip just spins (one was an Oxford one). Any tips to stop this happening?

MrsMiggins

2,867 posts

266 months

Monday 28th August 2017
quotequote all
I went for the R&G grips because I don't like the overt branding of 'Oxford' prominent on the grip.

Jazoli

9,707 posts

281 months

Monday 28th August 2017
quotequote all
jamiebae said:
I've actually looked at a couple of bikes where the grip just spins (one was an Oxford one). Any tips to stop this happening?
use more glue smile

wilbo83

1,552 posts

196 months

Monday 28th August 2017
quotequote all
jamiebae said:
I've actually looked at a couple of bikes where the grip just spins (one was an Oxford one). Any tips to stop this happening?
I wrapped my throttle tube / bar in electrical tape which increases the circumference and ensures a tight fit. Also used hairspray to help it on, dries quickly though so be quick.

Globs

13,847 posts

262 months

Tuesday 29th August 2017
quotequote all
Nath911t said:
I've had both Oxford and R&G and both were fine.
If i were to get another set it would be the Oxfords as don't they turn themselves off unless you relay wire them to stop the power when the ignition is off?
I wired mine to the light circuit as any other alternate seemed impossible. I does the job fine though, if you stop to fill up with fuel the V8 does switch itself off which sometimes you only notice when your hands start getting cold!

Also wiring to the lights stops any risk of battery flattening, they claim to sense engine off but why risk it?

jamiebae

Original Poster:

6,245 posts

242 months

Saturday 2nd September 2017
quotequote all
Heated grips are on, it was fairly easy (although I made a bit of a mess with the glue...) . I'm not impressed with the connections though, they're not even remotely weatherproof and the cables aren't long enough to get them tucked in behind the bodywork properly so I'll have to tape them up. They work fine, turn themselves off and the controller doesn't look too bad, I might spray the mount black though.


jamiebae

Original Poster:

6,245 posts

242 months

Saturday 2nd September 2017
quotequote all
I've also ordered a gear indicator from Ali Express for about $35, which plugs into the diagnostic port and supposedly works well according to a couple of people on an owner's forum so let's see if it turns up, and if it actually functions at all.

Volant

138 posts

159 months

Saturday 2nd September 2017
quotequote all
jamiebae said:
Heated grips are on, it was fairly easy (although I made a bit of a mess with the glue...) . I'm not impressed with the connections though, they're not even remotely weatherproof and the cables aren't long enough to get them tucked in behind the bodywork properly so I'll have to tape them up. They work fine, turn themselves off and the controller doesn't look too bad, I might spray the mount black though.

Rather than spraying the mount, if you have handlebars rather than clip ons, I use these...

https://www.ebay.co.uk/p/871164687?iid=12136157666...