JB Weld on engine casing?
Discussion
Looks as though I have a small pinhole in my Daytona 675's engine casing. It's bad enough to be spraying oil on the rear tyre but only when oil is warm and/or there's enough pressure in the casing.
I'm thinking of carefully prepping the area by first roughing it up with a steel brush and then giving it a proper cleaning down with some IPA/Brake cleaner before applying copious amounts of JB Weld with a trowel*
Damage occured when the front sprocket came off so there's no unknown internal engine malarkey going on.
Opinions and advice appreciated.
I'm thinking of carefully prepping the area by first roughing it up with a steel brush and then giving it a proper cleaning down with some IPA/Brake cleaner before applying copious amounts of JB Weld with a trowel*
Damage occured when the front sprocket came off so there's no unknown internal engine malarkey going on.
Opinions and advice appreciated.
- Not really...
I use Wurth Chemical Metal; comes as a stick with the two compounds separate; you cut a bit off, work it between your fingers for a bit to mix them and then just blob it on.
Amazing stuff; I have fixed holes in crankcases and petrol tanks, created new bearing housings and fixed countless monkey-metal children's toys with it.
Amazing stuff; I have fixed holes in crankcases and petrol tanks, created new bearing housings and fixed countless monkey-metal children's toys with it.
New casing complete is coming in at ~£1500, add labour onto that and it's more than the bike's worth.
Very unlikely the casing is cracked and certainly no evidence of that. There are some gouges in the aluminium casing, clearly from the chain, but when engine is cold there's no evidence of oil seeping out so it's an educated guess that it's only a pinhole.
TIG welding would mean engine out and dismantling. Would only do this if opinions were that JB Weld or similar wouldn't fix it as once I whack the epoxy on then welding is out of the question.
Good to hear about the Wurth epoxy, that's encouraging...
Very unlikely the casing is cracked and certainly no evidence of that. There are some gouges in the aluminium casing, clearly from the chain, but when engine is cold there's no evidence of oil seeping out so it's an educated guess that it's only a pinhole.
TIG welding would mean engine out and dismantling. Would only do this if opinions were that JB Weld or similar wouldn't fix it as once I whack the epoxy on then welding is out of the question.
Good to hear about the Wurth epoxy, that's encouraging...
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


