Testing HT Leads?
Author
Discussion

Riknos

Original Poster:

4,701 posts

235 months

Monday 4th September 2017
quotequote all
Hi guys,

So intermittent cutting out issue on my bike - was advised it could be coils. Tested with a multimeter, they're reading fine, so started moving onto testing plugs and leads - but I can't get any resistance rating on the leads? It doesn't read anything at all? What's the best way of testing these?

It's a 99 Hornet - The multi meter is definitely working OK - I borrowed my electrician friend's fancy expensive one, and it tests the coils fine but not the HT leads?

Thanks.

RizzoTheRat

29,143 posts

223 months

Monday 4th September 2017
quotequote all
Have you tried multiple leads or just the one? You should be able to measure the resistance, if you're getting an open circuit reading then it might well indicated the lead's completely buggered.

However measuring the resistance won't necessarily tell you if there's a problem. Usually when leads die it's the insulation that's broken down and they're earthing against the frame of the bike. You might be able to see arcing if you run the engine in the dark, but your running problems are worse on wet days there's a good chance it's the leads.

Fleegle

16,710 posts

207 months

Monday 4th September 2017
quotequote all
Riknos said:
What's the best way of testing these?
One finger in each and with the other hand press the starter. If you choose to do this, please ensure you have a GoPro running

Riknos

Original Poster:

4,701 posts

235 months

Monday 4th September 2017
quotequote all
RizzoTheRat said:
Have you tried multiple leads or just the one? You should be able to measure the resistance, if you're getting an open circuit reading then it might well indicated the lead's completely buggered.
Had no readings whatsoever on any 4 of the leads - hence the question. Want to rule out all ignition components as being ok before I start messing around with the carbs.