VFR 400 NC30 throttle issues - any thoughts?
VFR 400 NC30 throttle issues - any thoughts?
Author
Discussion

darkyoung1000

Original Poster:

2,496 posts

227 months

Saturday 16th September 2017
quotequote all
Evening all,

I'm having some issues with my NC30 and would welcome knowledge from the collective.

The bike starts fine, and idles ok (around 1300-1500 rpm), but there's an issue when snapping the throttle open. A quick blip from idle when warm, 'bogs' down the revs with a farting noise from the intake trumpets, before the revs rise. A delay of maybe a second.

Setting the idle artificially high (3000rpm) removes the problem, but causes the revs to fall more slowly.

So far I've checked the electrical circuit (battery, reg/reg all ok), balanced the carbs (a swine of a job), checked the carb rubbers for leaks (all ok) and changed the choke cable.

All this has taken some time, and it's still not great. My next step was to look at the carb diaphragms, then dismantle the carbs for a rebuild.

Anything glaringly obvious I've missed or suggestions to what it might be? I've considered the CDI but don't want to replace it 'just in case' as my instinct tells me it's fuelling related.

All tests conducted with an independent direct fuel supply btw.

Cheers,
Tom

Loyly

18,295 posts

190 months

Saturday 16th September 2017
quotequote all
It sounds like an intake leak, are you sure there isn't even a pinhole leak somewhere?

darkyoung1000

Original Poster:

2,496 posts

227 months

Sunday 17th September 2017
quotequote all
I sprayed WD40 all around the intake rubbers with the engine idling and there was no rise in RPM. I too say that having done that, I'd ruled them out as a source of potential air leak.
I'll have another go next time I fire it up though just to make sure.
Cheers,
Tom

Simes205

5,031 posts

259 months

Sunday 17th September 2017
quotequote all
I've got a set of nc30 carbs for sale if it helps you.

Rubin215

4,201 posts

187 months

Sunday 17th September 2017
quotequote all
Start with a fresh battery and new plugs; most carb related issues aren't.

If it's still not happy, strip the carbs and make sure all the jets are completely clear; it doesn't take a lot to block them.
Fit a new inline fuel filter too.

And I take it the valves have been done within living memory?

darkyoung1000

Original Poster:

2,496 posts

227 months

Monday 18th September 2017
quotequote all
The battery is ok, it's less than a year old, and a full test of that and the charging circuit show no problems.
I'll try the plugs and the CDI contacts next before moving on to inspect the diaphragms.
Thanks,
Tom