Not TVR But

[over_the_hill]

My back up car is a Rover 100 (Metro). The heater/blower has packed up. It is the three speed type. The cause is the blower resistor which just crumbled in my fingers when I was investigating the problem. I think this is a similar(ish) part to that used in some TVRs and I suspect a similar fault on my Chim as the blower isn't working on that either. Does anyone know if they are readilly available (tried a couple of scrap yards but they were all in an equally poor state) or the value of the resistances and I can make my own. i.e. speed 3 is zero ohms - direct connection.

[chimburt]

had one go on my old 216 over 10 years ago! - very common, new bit from Rover, job done.
not terribly expensive.
lord only knows where it is on the TVR though....