Old British twins
Discussion
On the old vertical twins, did the pistons come up together, or was one down when the other was up.
Just wondering having seen a post on FB, it said -
The Matchless G9 500 twin had pistons raising together and was the first motorcycle engine to exceed 5000 rpm
Just wondering having seen a post on FB, it said -
The Matchless G9 500 twin had pistons raising together and was the first motorcycle engine to exceed 5000 rpm
Edited by Vipers on Saturday 7th October 20:45
Up and down together, so sounds like a nice even during order. Japanese twins like the Honda 250 etc in the early 70s was the first thing I came across with pistons going ip and down alternately and it gave them that plup plup plup sound...or so it sounded to me anyway. No doubt there were loads of earlier examples too, but not the classic British stuff.
Back in the mists of time when I was a yoof messing with a 750 commando it was always the bottom end that was the weak point as it flexed at high (it’s all relative) revs.
Back in the mists of time when I was a yoof messing with a 750 commando it was always the bottom end that was the weak point as it flexed at high (it’s all relative) revs.
tvrolet said:
...Back in the mists of time when I was a yoof messing with a 750 commando it was always the bottom end that was the weak point as it flexed at high (it’s all relative) revs.
Bolted-together 3-piece crank (and no centre main bearing), not surprising that it flexed. 
All the British twins ended up way beyond their original design parameters.
Funnily enough, the Matchless/AJS twins were the only British parallel twins with a centre main. They weren't the first bike engines to exceed 5000 rpm, though. That certainly happened pre-war (IIRC the 1938 Speed Twin revved past 6000), my guess would be in the 1920s.
xeny said:
Eh? 180 degree crank the pistons move in opposition, so you get a rocking couple along the crank, quite different from a 360 degree crank or a single where all you have balancing the piston's weight is the crankshaft balance weights.
The vibration characteristics are still the same up and down. triples and fives are offset hence much smother. Its a bit more complicated than that but that`s the gist.Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


