A job never goes simple.
A job never goes simple.
Author
Discussion

2wheelsjimmy

Original Poster:

624 posts

128 months

Tuesday 10th October 2017
quotequote all
Replaced the wheel and head bearings and fork oil in my bike as needed doing.

Buttoned or back up, torqued to specs. Now it's got a real bad slow weve and gets wobbly banked over around corners at speed. At slow speed feels like it wants to lean left, then right and so on.

Irritating. I torqued the head bearing to spec, 25nm but wonder if it's too tight.

Guess I'll have it all apart again and put it all back together for a 2nd time checking all as I go. Fun!

Xtriple129

1,173 posts

188 months

Tuesday 10th October 2017
quotequote all
Head bearings too tight mate. Are you sure it's torque it up and leave it? Quite often you torque up to seat everything, then back off and do it to a lower spec..

2wheelsjimmy

Original Poster:

624 posts

128 months

Tuesday 10th October 2017
quotequote all
Xtriple129 said:
Head bearings too tight mate. Are you sure it's torque it up and leave it? Quite often you torque up to seat everything, then back off and do it to a lower spec..
Will check. I have the Honda service manual.

It says (from memory) tighten to 25nm then move yoke side to side 5 times then check torque is still 25.

anonymous-user

85 months

Tuesday 10th October 2017
quotequote all
25NM sounds way too high for the ‘set’ torque. Sounds more like a seating torque to me..

crusty

765 posts

251 months

Tuesday 10th October 2017
quotequote all
I always thought you nip it up until all the play has gone

anonymous-user

85 months

Tuesday 10th October 2017
quotequote all
Depends if it’s a taper roller or ball bearing.

But generally just a tad more after tightening to get zero play; 2-3lb ft so a few NM, and no more.

Biker's Nemesis

41,486 posts

239 months

Tuesday 10th October 2017
quotequote all
Sure it wasn't 2 - 5flb like the poster above says?

Can't say I have ever torqued head bearings.

CarsOrBikes

1,158 posts

215 months

Tuesday 10th October 2017
quotequote all
I'd have gone with a seating torque and repeat to re-seat with a 'nip', defo get it apart again, and check the bearings too.

2wheelsjimmy

Original Poster:

624 posts

128 months

Tuesday 10th October 2017
quotequote all
Ah! Perhaps the manual is for an older style of bearing (roller ball) and I'm using tapered...?


2wheelsjimmy

Original Poster:

624 posts

128 months

Tuesday 10th October 2017
quotequote all
said bearing in manual


2wheelsjimmy

Original Poster:

624 posts

128 months

Tuesday 10th October 2017
quotequote all
Embarrassingly too tight.

Oh well lose now, hopefully that's the issue sorted.

NITO

1,349 posts

237 months

Wednesday 11th October 2017
quotequote all
So should it have been 25nm, or not??

2wheelsjimmy

Original Poster:

624 posts

128 months

Wednesday 11th October 2017
quotequote all
Given that the bike handled well today, i'd say hell no (for tapered head race bearings)

I suspect manual (written in 2000) used different bearings.