How much power can i draw from USB, before flat battery ?
How much power can i draw from USB, before flat battery ?
Author
Discussion

l_nels

Original Poster:

36 posts

108 months

Tuesday 14th November 2017
quotequote all
I want to get a dashcam for my 10 plate v8 vantage roadster.

Ive been looking at either :
- https://www.aukey.com/products/stealth-1080p-dash-...
- https://goroav.com/collections/desktop-cam/product...

As they are the most discrete once fitted (i had a look at the blackvue but didnt like the look of it once i held it in place).

With either of the above units, until i have time to get it properly fitted i was planning on powering it from the usb socket in the center console cubby (the one where you rest your arm, not the little one by the gear stick).

If i was to leave these cameras on running, connected to the usb socket how long would they run before the car battery being flat ?

ATG

23,863 posts

303 months

Tuesday 14th November 2017
quotequote all
(Guess work: 100Ah for the battery and 100mA for the camera, so 1000 hours to run flat, maybe 500 hours to give a safety margin, so about 3 weeks. My gut instinct is that that is a conservative estimate.)

Gday2

219 posts

154 months

Tuesday 14th November 2017
quotequote all
@ATG:
You never have a full battery in your car! Only after being charged via a proper charger or long time on the trickle charger you have it full to its capacity.
With age and with low temperatures the battery is loosing capacity as well.
If I would make the calculation I would half yours. Just my experience.

Cheers

Christian

davek_964

11,375 posts

206 months

Wednesday 15th November 2017
quotequote all
It's really not that hard to connect it to the fuse panel.
Get one of those fuse carrier things (slots into an existing fuse slot but provides two sockets - necessary because there are no empty slots in the passenger footwell fusebox - at least, not on my 2006 V8V). Find a switched live, and use it there.
Buy a lighter socket, add a couple of spade connectors and connect it to the fuse carrier. Hide the lighter socket under the dash on the passenger side, plug the camera into it and job done - camera is now on a switched live.

Done this on all of my cars and works perfectly.