V12 Vantage Track
Discussion
Afternoon all,
Quick question - anyone know the wheel track (dimensions) on the V12 Vantage?
I put the V12 in the new garage yesterday and managed to scrape the bottom of the carbon splitter on the previously thought "gentle slope". A genius friend of mine has designed temporary and permanent fixes (see attached).
If I use the temporary fix - how far do the have to be spaced apart? Does anyone use any ramps like these? Do they have to be handmade?
Any other suggestions or advice? I am worried about damaging the splitter...
Cheers
Quick question - anyone know the wheel track (dimensions) on the V12 Vantage?
I put the V12 in the new garage yesterday and managed to scrape the bottom of the carbon splitter on the previously thought "gentle slope". A genius friend of mine has designed temporary and permanent fixes (see attached).
If I use the temporary fix - how far do the have to be spaced apart? Does anyone use any ramps like these? Do they have to be handmade?
Any other suggestions or advice? I am worried about damaging the splitter...
Cheers
I have exactly the same predicament.
My 'temporary' solution is simply to use a couple of (about 8 feet long) scaffold boards, parallel with the garage entrance, then cover with coconut mats.
When these are in position, the garage door cannot be closed. For that reason therefore, the driveway contour cannot simply be changed to match the height of the boards. The slope needs to be altered much further away from the garage entrance (as per your drawing), but I have not got round to dealing with that yet and as mentioned, exceptional rainfall might then be a concern.
Edited by Dewi 1 on Monday 27th November 14:16
As mentioned, the permanent fix could cause issues with rainfall.
If I were you I'd get a set of ramps made up, but they're going to need to be heavy duty steel - the car going over will probably be exerting 750kg plus on them at a time, so even 10mm thick steel will need reinforcing, or a brace welded onto the back that touches the floor.
Any decent metalwork shop should be able to make it for you and it won't be too expensive.
If I were you I'd get a set of ramps made up, but they're going to need to be heavy duty steel - the car going over will probably be exerting 750kg plus on them at a time, so even 10mm thick steel will need reinforcing, or a brace welded onto the back that touches the floor.
Any decent metalwork shop should be able to make it for you and it won't be too expensive.
Your mention of Alu has given me an idea, for a very easy to use system.
Ref. your diagram, where you show the line of the planks, you could use a large sheet of Alu, hinged at the furthest point from the garage door.
First open your garage door, simply lift and hinge over the Alu plate into position, then drive over.
Should be much easier than placing two planks in the precise location, and no risk of anything moving at the crucial moments.
Your visitors might ask, what is that metal plate for, but perhaps an excuse to show them your big engine.
Edited by Dewi 1 on Tuesday 28th November 16:11
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff





