Wheel Arch liner fitting advice
Discussion
The liner (carpet type stuff) above and in front of my drivers side front wheel does not fit correctly. When the car was in to the dealer I asked them to sort it and they improved it a little but said that’s as good as it gets. I know it’s not the end of the world but I notice it.
I have done some prodding about and it seems to me that there is a rubber pipe in that section (I presume for the headlight washer?) that weighs on the liner from behind causing it to deform.
Is there a way to resolve this. Any tricks or tips on this liner stuff. If I push it into position it’s fine but as soon as I remove the pressure it drops again.


I have done some prodding about and it seems to me that there is a rubber pipe in that section (I presume for the headlight washer?) that weighs on the liner from behind causing it to deform.
Is there a way to resolve this. Any tricks or tips on this liner stuff. If I push it into position it’s fine but as soon as I remove the pressure it drops again.
8Tech said:
I would say that its probably been too low for so long it has now taken that shape. The hose should not rest on the liner, it should be clipped up.
I think you will need to replace or repair the liner and secure the hose properly.
Thanks for your reply. I have been out to the garage and had a good rummage and cant see where the hose would have been clipped previously, the underside of the front fairing is smooth in all of the area i would expect a clip to be to hold the hose. Hose does seem a little longer than necessary, are they all like that, it meanders in a half curl rather than going directly along the profile?I think you will need to replace or repair the liner and secure the hose properly.
I have cut up a piece of plastic piping to wedge the liner in its correct position using the wheel. Although i doubt it will work I shall see if it is any better in the morning at holding form. Fingers crossed.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff



