DB9 Rear Cabin Lights
DB9 Rear Cabin Lights
Author
Discussion

westhumbler

Original Poster:

163 posts

107 months

Thursday 25th January 2018
quotequote all
I've just tried to replace one of the rear cabin lights on the pillar. The lens came off fine, but there was a fitting behind this into which the lamp holder fitted. This has fallen down inside the pillar. Any ideas how to retrieve and before I "do" the other side, is there a method to avoid losing the fitting?

yvr

366 posts

177 months

Thursday 25th January 2018
quotequote all
I had the same experience. There's a metal bracket that I think is meant to position the lamp properly. I ignored it and was able to re-position the lamp without it.

During another project I removed many rear interior panels and finally found the errant bracket. It's a huge job to get it back, so if you don't need it (and it doesn't rattle), just assume it's lost forever.

westhumbler

Original Poster:

163 posts

107 months

Thursday 25th January 2018
quotequote all
I've got it roughly positioned using some gaffer tape behind the lens, but it's not a very elegant solution and I'm concerned that of the gaffer tape loses it's stickyness I'll lose the lamp down the pillar too. How did you position your holder without the metal bracket?

yvr

366 posts

177 months

Thursday 25th January 2018
quotequote all
It was some time ago, but I believe I pulled the whole lamp housing out, replaced the bulb and reassembled, then just pushed the lamp assembly back into the hole.

shuzzy

294 posts

245 months

Friday 26th January 2018
quotequote all
I did the same on my 2007 DB9 and had the same issue, the metal bracket dropped behind the trim panel and I was left holding just the plastic light. However I found just slipping the lamp holder clicked back together into the trim hole was perfectly fine. It's a nice tight fit so they don't move or wiggle about and the lack of the metal bracket made no discernible difference.