Loud bang from rear suspension - DB9
Discussion
Hi all,
A little help please
I head a slight clunk the last time I took my 2005 DB9 Manual out when either braking or accelerating, tonight I took my car out to bed in new front discs and pads and was obviously transitioning from moderate braking to moderate acceleration and at a certain effort, I get a loud bang under the drivers side rear of the car, similar as someone else has described to a lump hammer being hit under the car.
A quick look under in the wet and dark didn't reveal anything but a quick searching here appears to suggest a split resr lower arm casing allowing the arm to slide on its bushings, this does feel like just the fault.
Has anyone had this problem and where and how did they fix it?
Thanks
John
A little help please
I head a slight clunk the last time I took my 2005 DB9 Manual out when either braking or accelerating, tonight I took my car out to bed in new front discs and pads and was obviously transitioning from moderate braking to moderate acceleration and at a certain effort, I get a loud bang under the drivers side rear of the car, similar as someone else has described to a lump hammer being hit under the car.
A quick look under in the wet and dark didn't reveal anything but a quick searching here appears to suggest a split resr lower arm casing allowing the arm to slide on its bushings, this does feel like just the fault.
Has anyone had this problem and where and how did they fix it?
Thanks
John
Yes I had already planned to get a wheel alignment, it's well overdue.
Whilst TIG welding cast ally is possible, I am concerned about getting the hole in the arm to the exact same size as it should be so that the Bush doesn't keep slipping back and forth.
I think a new arm is the only sure way
Whilst TIG welding cast ally is possible, I am concerned about getting the hole in the arm to the exact same size as it should be so that the Bush doesn't keep slipping back and forth.
I think a new arm is the only sure way
This was similar to a thread we had a while back about replacing the spherical joints/bushes.
It is not a good idea to replace these in aluminium arms because of the likelyhood of actually causing these fractures and I suspect that this is why (in my experience) Astom Martin and BMW only offer exchange arms when made from cast aluminium.
Clearly, they had to be pressed in originally, but rather than using tons of hydraulic pressure to install, I suspect the arms are heated and the bushes/joints are frozen to allow installation.
There is absolutely no chance I would consider welding a cast aluminium arm and then trying to press in a replacement joint.
It is not a good idea to replace these in aluminium arms because of the likelyhood of actually causing these fractures and I suspect that this is why (in my experience) Astom Martin and BMW only offer exchange arms when made from cast aluminium.
Clearly, they had to be pressed in originally, but rather than using tons of hydraulic pressure to install, I suspect the arms are heated and the bushes/joints are frozen to allow installation.
There is absolutely no chance I would consider welding a cast aluminium arm and then trying to press in a replacement joint.
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


