Carbon light insert repair / removal / refitting
Carbon light insert repair / removal / refitting
Author
Discussion

anonymous-user

Original Poster:

85 months

Monday 2nd April 2018
quotequote all
Hello,

I noticed last time I used my car that the outer edge of the carbon light insert (08 / V8V), has some small chips in the lacquer.

I assume this is because the fit is slightly out and is allowing movement at high speed; so is there an AM process for removal and refitting, it looks like they are just stuck down? Which I want to do before the thing comes flying off!

Secondly, has anyone attempted to refinish the lacquer? I am only talking about a very small area (perhaps three 4x4 mm chips). Last time the car was in at AM they quoted £500+ for a new insert and then advised me to look at getting it refinished.



Chris.Owen

110 posts

104 months

Monday 2nd April 2018
quotequote all
I can’t speak for carbon, as it’s obviously much stiffer so slightly different to remove. But it’s essentially glued and has 2 spring clips, one near either end. Get some plastic trim removal tools and gently prise it off, I did a plastic one yesterday whilst swapping out a duff rear light. It’s pretty easy. I’d assume any decent body shop could re laquer it for you. Or dare I suggest rattle cans?!

anonymous-user

Original Poster:

85 months

Monday 2nd April 2018
quotequote all
It’s come away from the light right at the curved ‘thin’ end so I am wondering if it hasn’t been reinstalled properly.

You don’t happen to have a manual / pdf do you?

Conscious I don’t want any spring clips to go ‘missing’ ...

I’m happy to (try) and rattle can it, but will do a test piece first!

Manwhoneverwas

598 posts

162 months

Monday 2nd April 2018
quotequote all
Apply gentle heat to the CF insert to soften the double sided tape that hold the inserts down to the light
Then use fishing line to get in behind the insert and separate the CF insert from the light.
Just be careful and work slowly as you don't want to damage the CF insert.

anonymous-user

Original Poster:

85 months

Monday 2nd April 2018
quotequote all
Excellent I shall try that, my concern was it was someone affixed from the inside aswell.

Now to find a way to ‘repair’ the lacquer, I might try clear nail varnish just to stop any carbon delaminating (if it can) whilst I search for some new inserts.

telum01

987 posts

146 months

Monday 2nd April 2018
quotequote all
Lord.Vader said:
I assume this is because the fit is slightly out and is allowing movement at high speed; so is there an AM process for removal and refitting, it looks like they are just stuck down?
Watch the first few minutes of this for removal, and the last few minutes for refitting:
https://www.youtube.com/watch?v=-GNUgU7xT9s