V8V fuel cap broken.
V8V fuel cap broken.
Author
Discussion

Muffster

Original Poster:

312 posts

224 months

Saturday 7th April 2018
quotequote all
I've managed to break fuel filler cap today whilst filling up. I put the cap into the holder on the filler flap, pressed it in quite firmly as its fallen out it the past and banged on the rear wing. When i pulled it out of the flap, stay with me here...! The underside of the cap, the white bit with the peg on it pinged off, thankfully onto the forecourt and not down the filler neck.
So the picture below is the bits I'm left with. The large white piece will not fit back into the cap, there must be another piece missing. I can't really work out what they are for other than a mechanism to stow the cap when filling up and it looks like its over engineered to be honest.
So, has anyone else had this, i'm guessing the cap can only be bought as one whole piece.
And, be careful out there folks, don't put your little peg in the hole too hard 'cos it'll fall off like mine did!


rovcallum

553 posts

174 months

Saturday 7th April 2018
quotequote all
Ahaaah, finally someone else with the same problem I had. See below...

https://www.pistonheads.com/gassing/topic.asp?t=16...

In fact, no one on here managed to give me any advice but mine clicked back together and has not been any problem since.
I think the spring creates a non-return/breather valve assembly in the bottom of the cap but I could be wrong.

Anyway, persevere with it, I think you have all the parts. From memory, it goes together as below, spring first... (forgive the sketch)



Edited by rovcallum on Saturday 7th April 19:15

Muffster

Original Poster:

312 posts

224 months

Saturday 7th April 2018
quotequote all
I'm not alone! Thanks for the post rocallum.

I have put the spring and the small 3 pronged piece back in place but when i offered the larger piece up i couldn't figure out how it sat in there. It obviously only goes in one way but It just spins around with nothing to connect or clip into to fit into or hold it in place. How did you do it?

As a temporary job I've covered the filler cap in masking tape so it doesn't damage the paint at the petrol station!

dalecan

317 posts

282 months

Saturday 7th April 2018
quotequote all
This happened to me too. Fortunately i managed to grab the parts before they completely separated and I just had to push them firmly back together. It hasn’t happened since.
Every now and them I just make sure that these parts are firmly pushed together.

cadman

22 posts

133 months

Tuesday 10th April 2018
quotequote all
happened to Me too ,"2007 V8V " i used some fine grit emery cloth and sanded down the spigot on the cap a little so it fit the hole slightly looser.. i lost the spring when it fell apart,had to make one up for temp fix, if it does'nt seal at the right pressure it will throw a evap leak code as it did for me...
mazda 3 or 5 filler caps fit the V8V aftermarket Stant # 10851.only $15 bought one of them no trouble since , a lot cheaper than a new A.M cap might take the guts out and put the spring in the OEM cap.