DB9 misfire monitor
Discussion
from about 16,000 mile my 2005 DB9 always had a slight idling misfire, had the plugs and coils replaced a couple of years ago but even then never seemed 100%.
I watched Aston 1936 video on using a generic obd reader to check misfires, my old OBD reader found the live data for all 12 cylinders but all had zero misfires, very odd,i dont think any engine can ever achieve zero misfires & i can feel the miss plain as day.
After a bit of internet research i came across a code reader with OBD and Aston Martin software for £179!!, it shows that the misfire monitor is "not enabled"
,all the other monitors are "enabled" and yield live data, surely the monitor should be enabled as we all know the results of a serious misfire in our cars is pretty catastrophic.
Can anybody familiar with the proper AMD enlighten me please.
Recently i have changed the air filters and found traces of oil on them, time for PCV valve replacement so the manifolds are coming off if i have to do the plugs and coils again this would be the perfect time.
thanks in advance
craig
I watched Aston 1936 video on using a generic obd reader to check misfires, my old OBD reader found the live data for all 12 cylinders but all had zero misfires, very odd,i dont think any engine can ever achieve zero misfires & i can feel the miss plain as day.
After a bit of internet research i came across a code reader with OBD and Aston Martin software for £179!!, it shows that the misfire monitor is "not enabled"
,all the other monitors are "enabled" and yield live data, surely the monitor should be enabled as we all know the results of a serious misfire in our cars is pretty catastrophic.
Can anybody familiar with the proper AMD enlighten me please.
Recently i have changed the air filters and found traces of oil on them, time for PCV valve replacement so the manifolds are coming off if i have to do the plugs and coils again this would be the perfect time.
thanks in advance
craig
When my coilpacks started failing at about 35K miles I tried to read the OBD codes -- nothing much showed up but I could see that the misfire corrections weren't stored. Did the coast down, verified the corrections were stored. Only then did I start seeing misfires being recorded.
I had to head out at 5am to avoid traffic while doing the coast down.
I had to head out at 5am to avoid traffic while doing the coast down.
Finally got chance to do run down and now have misfire counts.
Drove round for an hour then connected reader
Cyl 1 , 1
Cyl 2, 6
Cyl 3, 5
Cyl 4, 4
Cyl 5, 4
Cyl 6, 4
Cyl 7, 19
Cyl 8, 7
Cyl 9, 18
Cyl 10, 2
Cyl 11, 0
Cyl 12, 1
My question is, Are these acceptable misfire values for this engine?,
Thankyou
Craig
Drove round for an hour then connected reader
Cyl 1 , 1
Cyl 2, 6
Cyl 3, 5
Cyl 4, 4
Cyl 5, 4
Cyl 6, 4
Cyl 7, 19
Cyl 8, 7
Cyl 9, 18
Cyl 10, 2
Cyl 11, 0
Cyl 12, 1
My question is, Are these acceptable misfire values for this engine?,
Thankyou
Craig
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


