Stop!
Author
Discussion

ilikeAstons

Original Poster:

275 posts

135 months

Monday 14th May 2018
quotequote all
Morning everyone. I need to improve my stopping power - my front pads need replacing.

Kinda keen to get it done before I go to this years Le Mans - My car is a 2008 DB9, and I understand the OEMs are Pagid. Is this correct? And if so, I'd love a part number for the fronts.

But whilst I ask, I have another question.... I think Pagids are 'dusty' and squeakers... is there a better way to go? Again, part numbers would be highly appreciated.


James

HBradley

1,037 posts

212 months

Monday 14th May 2018
quotequote all
ilikeAstons said:
Morning everyone. I need to improve my stopping power - my front pads need replacing.

Kinda keen to get it done before I go to this years Le Mans - My car is a 2008 DB9, and I understand the OEMs are Pagid. Is this correct? And if so, I'd love a part number for the fronts.

But whilst I ask, I have another question.... I think Pagids are 'dusty' and squeakers... is there a better way to go? Again, part numbers would be highly appreciated.


James
James,
Have a look at Rich's Redpants website, he recommends these (http://www.porterfieldbrakes.co.uk/brake-pads.html?cars=692). Less dust/squeaks better stopping power, can't speak from experience though.

bogie

17,107 posts

303 months

Monday 14th May 2018
quotequote all
Im going to try some performance friction next http://www.davidapplebyengineering.com/page49.html

OE are Pagid RS4-2-2 and need fitting with their backing pads and some anti squeal stuff, AND bedding in properly from time to time. They glaze over with months of light use and when they start being noisy just re-bed them in.

Ive tried some EBC red and they squeal too, even after bedding in. Much less dust though.

huntsen

137 posts

124 months

Monday 14th May 2018
quotequote all
ilikeAstons said:
Morning everyone. I need to improve my stopping power - my front pads need replacing.
Kinda keen to get it done before I go to this years Le Mans - My car is a 2008 DB9, and I understand the OEMs are Pagid. Is this correct? And if so, I'd love a part number for the fronts.
But whilst I ask, I have another question.... I think Pagids are 'dusty' and squeakers... is there a better way to go? Again, part numbers would be highly appreciated.
James
Without any doubt, go for the Porterfield R4-S, available from Porterfield UK www.porterfieldbrakes.co.uk.
I put the rears onto my V8 Vantage last year; they are much cleaner and there's absolutely no squeal (didn't even bother to bed them in).
The fronts will be done at the end of this season.
If you or someone you know goes to the States, Rich of Redpants will send the pads to your nominated address, thereby saaving the hassle of trans-Atlantic freight and customs charges.

Jibberingloon

851 posts

231 months

Monday 14th May 2018
quotequote all
bogie said:
Im going to try some performance friction next http://www.davidapplebyengineering.com/page49.html

OE are Pagid RS4-2-2 and need fitting with their backing pads and some anti squeal stuff, AND bedding in properly from time to time. They glaze over with months of light use and when they start being noisy just re-bed them in.

Ive tried some EBC red and they squeal too, even after bedding in. Much less dust though.
I did exactly this, got James at DAE to put some Performance Friction Pads on and they have improved the stopping power x4! take a little time to bed in, but 100% worth it.

rovcallum

553 posts

174 months

Monday 14th May 2018
quotequote all
bogie said:
Ive tried some EBC red and they squeal too, even after bedding in. Much less dust though.
Last year I ran with the standard Pagids.
I fitted EBC reds (front pads) recently and after a good bedding in routine, I find they only squeak a little bit at very low speed. They produce a lot less dust though. Much cheaper and more obtainable than Porterfield.

Gday2

219 posts

154 months

Tuesday 15th May 2018
quotequote all
I had the EBC Red Stuff, dust wise the best pads I ever had on any car. Braking very good even when I gave them agony on Pass-streets in the Alps, no way to kill them on road. Fried them on the Red Bull Ring, no more red color, they were black but still going strong on road afterwards for about 5000 Km.
I replaced them with Yellow Stuff, great pad but did not see the Red Bull Ring yet smile
I can recommend both.
Cheers

Christian

a98pmalcolm

213 posts

108 months

Wednesday 16th May 2018
quotequote all
We stock the Mintex M1144's and M1155's if thats any interest to you?

https://www.akstuning.co.uk/mintex/250-mintex-m114...

DB9 Calipers are are the same as Audi TTRS

Any performance pad will squeak