Tyre valve cover grub screw size
Discussion
That is a very common accessory part avaiable from both Aston Martin and the aftermarket.
They are theft resistant logo valve caps and are usually aluminium with a 0.5 or 0.75mms grub screw to lock them.
Your Allen key could well be in your tool kit.
I advise lightly lubricating the thread when refitting to eliminate any corrosion between the cap and the valve stem.
They can be undone with an 11mm spanner usually when tight but undo the grub screw first because it locks against the brass thread of the valve.
It is to lock the cap in place so it cannot get stolen by finger grip only.
They are theft resistant logo valve caps and are usually aluminium with a 0.5 or 0.75mms grub screw to lock them.
Your Allen key could well be in your tool kit.
I advise lightly lubricating the thread when refitting to eliminate any corrosion between the cap and the valve stem.
They can be undone with an 11mm spanner usually when tight but undo the grub screw first because it locks against the brass thread of the valve.
It is to lock the cap in place so it cannot get stolen by finger grip only.
Edited by 8Tech on Monday 28th May 13:26
They look pretty corroded and you might be able to loosen off that grub screw with some thin pliers as it SHOULD only be nipped up.
You can always refit them without locking them on again because the sight of the grub screw is normally deterrent enough.
If I were you though, I would get myself a nice newest and use the key they will come with to remove the old ones. Clean them up and you have some spares.
You can always refit them without locking them on again because the sight of the grub screw is normally deterrent enough.
If I were you though, I would get myself a nice newest and use the key they will come with to remove the old ones. Clean them up and you have some spares.
Edited by 8Tech on Wednesday 30th May 17:53
Take extreme care in trying to remove the dust cap once you have the grub screw removed. I say this as I experienced something similar when an aftermarket cap had corroded itself onto the value. When trying to loosen the cap, even after copious amounts of WD40 and very little pressure applied, the valve stem broke. This results in immediate loss of total tyre pressure and either needing a tow truck or a spare wheel. And of course a nice invoice for a new TPMS valve. Good luck
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


