Hello everyone

[Big Musky]

Hello everyone I am new to the site and wonder if you can advise me on how to connect steel to nylon fuel lines. I know there are compression joints for metal to nylon pipe connecting, and other fittings that can be used to fit to nylon fuel lines. My car is a Ford Mondeo mark three petrol and I want to cut out rusty sections of the fuel feed and the other line from the purge valve. Thanks in advance.

[GreenV8S]

I don't use them myself, but I see this sort of thing which might be what you're looking for:

https://www.amazon.com/Dorman-800-135-Nylon-Steel-...

For what it's worth, if I was replacing rusty fuel pipes I'd want to replace the whole run, not just the sections that were obviously rusty.

[Big Musky]

Thanks GreenV8S yes you are right it would be better to replace the full line, the Ford originals are around £220 for the metal lines. I will check out the fittings you mentioned.