Anyone fitted a quiet switch to a Vanquish?
Anyone fitted a quiet switch to a Vanquish?
Author
Discussion

kalibre46

Original Poster:

278 posts

162 months

Tuesday 26th June 2018
quotequote all
I know it sounds a bit odd and of course I love the sound of my car....however, I might start occasionally using the car a bit earler in the morning and the startup noise is a little bit too much for 5am. So being a courteous neighbour I thought I'd see if there were any solutions out there to stop or quieten the initial blip up the rev range upon startup. I'm thinking a hidden switch or something of the like. I was going to message Bamford Rose directly but I thought I'd canvas opinions on here first.

Anyone looked at a similar solution before?

Jibberingloon

851 posts

231 months

Tuesday 26th June 2018
quotequote all
Car will start with exhaust flaps closed all the time

So the issue is the cold start where there is more fuel being injected into the engine which causes the extra noise etc.
This is done to help the engine warm up quicker and safer. It could be taken out with a remap to ecu, but i wouldnt as its there for a reason.

PS..... sod the neighbours! or buy a bigger house in the country where no one will hear the beautiful v12 exhaust notes................

jonby

5,367 posts

188 months

Tuesday 26th June 2018
quotequote all
kalibre46 said:
I know it sounds a bit odd and of course I love the sound of my car....however, I might start occasionally using the car a bit earler in the morning and the startup noise is a little bit too much for 5am. So being a courteous neighbour I thought I'd see if there were any solutions out there to stop or quieten the initial blip up the rev range upon startup. I'm thinking a hidden switch or something of the like. I was going to message Bamford Rose directly but I thought I'd canvas opinions on here first.

Anyone looked at a similar solution before?
All Astons are programmed to have the valves open on start up, so the only way would be to fit a three way switch, with one of the options being to permanently close the valves - the two way switches tend to be for choosing between valves permanently open and valves closing/opening based on revs so wouldn't address your problem

There are a couple of ways of fitting such a switch for relatively modest money - BR is a sensible route for a 3 way switch

jonby

5,367 posts

188 months

Tuesday 26th June 2018
quotequote all
Jibberingloon said:
Car will start with exhaust flaps closed all the time
..
As I understood it, the flaps are programmed to open at low revs on start up as per my post ? Certainly that's what I understood for Vantage/DB9/DBS. Very happy to stand corrected

MarkM3Evoplus

862 posts

231 months

Tuesday 26th June 2018
quotequote all
Have a 3 way switch on an original Vanquish - quiet all the time, standard & noisy all the time.

Bamford Rose fitted it.

Jibberingloon

851 posts

231 months

Tuesday 26th June 2018
quotequote all
I stand corrected!

Always thought they start Closed and only open above 4000rpm....

kalibre46

Original Poster:

278 posts

162 months

Tuesday 26th June 2018
quotequote all
Thanks all.

MarkM3Evoplus said:
Have a 3 way switch on an original Vanquish - quiet all the time, standard & noisy all the time.

Bamford Rose fitted it.
That's good to hear. So upon start-up when it blips up the range is it much quieter in the 'quiet all the time' mode?

MarkM3Evoplus

862 posts

231 months

Tuesday 26th June 2018
quotequote all
Yes, goes through rear silencer all the time in quiet mode.