Wilwood clutch master cylinder

[Jhonno]

Anyone have one of these fitted? Seen a couple of people mention it when fitting them with the Tilton slaves.. What adapters/fittings did you use?

[pmessling]

yes fitted one a couple of weeks ago, you'll need the pipe adapter 3/8th - 7/16th UNF, you'll also need to replace the end clevis.

Demon Tweeks part number for master cylinder WIL260-6579,
Demon Tweeks part number for quick release clevis OBPCB005S

Careful of the pipe adapter as i managed to sheer one, there isn't much room.

A useful tip to make changing the master cylinder easier and a one man job is to thread the holes on the master cylinder to M10, it takes a thread easy as its aluminum.

Haven't driven mine yet with the new cylinder i'm just finishing off my linked decat pipes. so hopefully next week.

[Jhonno]

Have you got a link to the adapter you used Peter?

I found out about the Clevis.. So sorted that bit and have it mounted in the car.

[Jimm218]

The adapter is of an mg midget (at least the one i have is). Moss bros have them listed. It makes a tight space tighter but it does all just about go in.

[Jhonno]

Jimm218 said:

The adapter is of an mg midget (at least the one i have is). Moss bros have them listed. It makes a tight space tighter but it does all just about go in.

Ah, OK, I have one of those from my old master..

[pmessling]

https://www.carbuildersolutions.com/de/brass-union...

[pmessling]

Willwood master and adapter