Can i make (or re-attach the plug) to an HDMI cable?
Can i make (or re-attach the plug) to an HDMI cable?
Author
Discussion

sjtgeray

Original Poster:

323 posts

218 months

Friday 10th August 2018
quotequote all
My HDMI cable runs in a conduit in the wall to get the signal up to a wall mounted TV. When it was installed i asked the builders to use a big enough plastic conduit so i could run other cables through it if needed. They ran the cable through it and all was good...one end popping out at the bottom, and one at the top.
The cable is now buggered (cabinet got pushed against the wall and has bent the plug end of the cable to 90 degrees, and it doesnt want to work). Simple i think, simply tape the new cable to the top end of the old, and pull the old cable down through the conduit, and the new one will come along too.
BUT...the stupid builders have used conduit that isnt big enough to get the plug end of an HDMI cable through. In fact its not even big enough to get even the connector bit through (without the surround). Dont really know how the builders put it in. Maybe the conduit has a split all the way down and they simply opened it, put the cable in, closed it, then buried it in the wall.

So my only option is to run a cable with no connectors/plugs on it down the conduit, but then of course i need to attach an end to plug it into the Sky/Xbox
Doesnt look like you can easily crimp a connector on so I am at something of a dead end, having to watch tv with a cable dangling across the outside of the wall. Any idea please folks ?

SS2.

14,712 posts

269 months

Friday 10th August 2018
quotequote all
How's your soldering ?

egomeister

7,614 posts

294 months

Friday 10th August 2018
quotequote all
How about running a network cable then using a HDMI adapter?

Something like this: https://www.amazon.co.uk/Neet%C2%AE-Extender-Cat5e...

peterperkins

3,459 posts

273 months

Saturday 11th August 2018
quotequote all
I did similar. Just order a long enough pre-made cable.
Cut one of the plugs off a couple of feet from the end.

Pull it through then rejoin the cables (by soldering and insulating each wire and screen in turn.)
There are a lot of small wires in an hdmi cable!
Try and keep the screening intact.Don't short stuff..
Secure the whole lot and seal it with decent tape or shrink wrap etc,
Works fine..

Phunk

2,102 posts

202 months

Saturday 11th August 2018
quotequote all
Could you run a mini hdmi cable then just use adapters at each end?

sjtgeray

Original Poster:

323 posts

218 months

Saturday 11th August 2018
quotequote all
Thanks all. Having watched a few YT videos i have concluded my soldering is not up the job !!
The mini hdmi and converters sounds like an option....i will try that first i think

chasingracecars

1,697 posts

128 months

Saturday 11th August 2018
quotequote all
Drop me a PM one of my suppliers has just launch a solution for you.

megaphone

11,724 posts

282 months

Sunday 12th August 2018
quotequote all
I've used a screw terminal connector in the past, it's a fiddly job as the cables in the HDMI lead are often tiny, may be worth a try.
eg

https://www.amazon.co.uk/Adapter-signals-Terminal-...

sjtgeray

Original Poster:

323 posts

218 months

Monday 13th August 2018
quotequote all
Thanks all for input. Having concluded the soldering options as too tricky and specialist cable pretty pricey, I've got a buidler mate to quote on carving out a new channel, inserting some bigger conduit, and replastering.
Also fixes a crack in the wall the wife has been moaning about. So £100 plus a repaint of the wall by me and we are future proofed with some extra space for future cables. Seems like the winner !

tight fart

3,623 posts

304 months

Monday 13th August 2018
quotequote all
Cut the end off and pull cat 5 through, then use a HDMI over cat5 kit. go for a poe version like the Labgear hdx60p.

sjtgeray

Original Poster:

323 posts

218 months

Monday 13th August 2018
quotequote all
Thanks all for input. Having concluded the soldering options as too tricky and specialist cable pretty pricey, I've got a buidler mate to quote on carving out a new channel, inserting some bigger conduit, and replastering.
Also fixes a crack in the wall the wife has been moaning about. So £100 plus a repaint of the wall by me and we are future proofed with some extra space for future cables. Seems like the winner !