Unifi AP location advice
Discussion
I'm looking for some advice on a new Ubiquiti Unifi setup.
Building contains several flats and the first use case is to allow strong 2.4G wireless access to a couple of security cameras. The second use case is to have two vlans - one for the cameras and one for the residents.
Below is a drawing of the layout - red are the two cameras.
Can I get away with one powerful access point (green) to serve both from the landing?
Or will I need an additional external access point (pink) to service device 2?
I won't be able to mount and power an external AP for device 1.

Building contains several flats and the first use case is to allow strong 2.4G wireless access to a couple of security cameras. The second use case is to have two vlans - one for the cameras and one for the residents.
Below is a drawing of the layout - red are the two cameras.
Can I get away with one powerful access point (green) to serve both from the landing?
Or will I need an additional external access point (pink) to service device 2?
I won't be able to mount and power an external AP for device 1.

RockyBalboa said:
Both of these devices are hard wired to power but they only operate wirelessly.
I'd consider other devices then.As thebraketester notes, I'd be hard wiring. You can get loads of PoE cameras and the Unifi AP range is also PoE. So if you can get T&E to the devices, you can get Cat5e there too (indeed that's what I'd do).
The Unifi LR devices ("more powerful") have limited use cases. The general advice is to have more of the std versions (ask me how I know!).
Everything else will be a bit of a case of "it depends"...you'd need to test it and it'll be a bit trial and error.
What are you doing with the ground floor? Are you putting the APs noted in the roof void?
Do tenants expect WiFi these days? Are you providing an internet connection too? I think 1x AP where you have it will struggle to provide a decent signal all over that building.
Just to come back on this.
i have it all set-up and running great now.
I initially used UAP-AC-PROs but realised they were overkill so instead got 2 UAC-AC-LRs and an outdoor UAP-AC-M. After testing various positions and connectivity, the setup works great for internal and external devices.
i have it all set-up and running great now.
I initially used UAP-AC-PROs but realised they were overkill so instead got 2 UAC-AC-LRs and an outdoor UAP-AC-M. After testing various positions and connectivity, the setup works great for internal and external devices.
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff


