What are these marks/blemishes on my Alloys ?
What are these marks/blemishes on my Alloys ?
Author
Discussion

CrowthxD

Original Poster:

3 posts

92 months

Thursday 23rd August 2018
quotequote all
Hi, I’ve had my car about a year now and I’ve noticed these marks appearing on my alloy wheels.

Not sure what they are, they are not scuffs and are smooth to the touch almost as if they are part of the finish.

Not sure what they are or how to remove them...any ideas please!



CrowthxD

Original Poster:

3 posts

92 months

Thursday 23rd August 2018
quotequote all

aka_kerrly

12,498 posts

234 months

Thursday 23rd August 2018
quotequote all
those look like diamond cut finish and water has gotten under the top coat. sadly there is not lot that can be done without re cutting and sealing them.

CrowthxD

Original Poster:

3 posts

92 months

Thursday 23rd August 2018
quotequote all
Is there anything I can do to prevent it from getting any worse or happening in other places ? It’s not too bad at the moment as only a couple of small marks on each wheel!

7even

462 posts

217 months

Tuesday 28th August 2018
quotequote all
CrowthxD said:
Is there anything I can do to prevent it from getting any worse or happening in other places ? It’s not too bad at the moment as only a couple of small marks on each wheel!
You can, by ways of sanding back and re sealing with clearcoat, aesthetically it would look terrible. So tbh I wouldn't entertain that thought.

Having them re cut is about the only method for an OE finish. Other options, if your not too fussed about the diamond cut face, would be to have them either wet painted or powder coated. Which would be a lot more durable than the finish at the moment.

plfrench

4,393 posts

292 months

Thursday 30th August 2018
quotequote all
You say you've had the car about a year - is that from new? If so, I'd investigate if this would be covered under warranty. The first image in particular doesn't look as though there has been any damage to the surface of the wheel such as kerbing. If this has occurred without damage after a year I'd think there'd be good cause to claim the coating wasn't fit for purpose.

irocfan

46,833 posts

214 months

Thursday 30th August 2018
quotequote all
aka_kerrly said:
those look like diamond cut finish and water has gotten under the top coat. sadly there is not lot that can be done without re cutting and sealing them.
this ^^^ happens on a lot of wheels frown

Blue62

10,305 posts

176 months

Saturday 8th September 2018
quotequote all
I take it the wheels have been refurbished at some point? It's water under the clear coat and I don't think there's much you can do other than to get them referred again, though there's every chance the problem will return.