DC adapter question
Author
Discussion

tenohfive

Original Poster:

6,276 posts

213 months

Tuesday 28th August 2018
quotequote all
I recently bought a used monitor supplied without any cables - I didn't think it'd be an issue as every monitor I've owned takes a kettle lead. This one doesn't - it takes a DC input.

On the manual it says under power supply AC 100-240 V ~ 50/60 Hz (DC 19V 2.1A.)

I've got a few old AC adapters knocking around - a 10V 1.2A output, a 9V 0.6A output and a 12V 2A output adapter. Will any of these do the job or do I need to buy a specific adapter?

fat80b

3,255 posts

252 months

Tuesday 28th August 2018
quotequote all
tenohfive said:
On the manual it says under power supply AC 100-240 V ~ 50/60 Hz (DC 19V 2.1A.)

I've got a few old AC adapters knocking around - a 10V 1.2A output, a 9V 0.6A output and a 12V 2A output adapter. Will any of these do the job or do I need to buy a specific adapter?
No - You need a 19V adapter capable of delivering up to 2.1A and the right connector.

This sounds like a laptop power supply would do they job as they tend to be 19V.

tenohfive

Original Poster:

6,276 posts

213 months

Tuesday 28th August 2018
quotequote all
Bugger. That basically adds 40% or so to the overall cost of the thing.

I take it more than 2.1A is fine, but less is not?

Edited by tenohfive on Tuesday 28th August 10:42

megaphone

11,723 posts

282 months

Tuesday 28th August 2018
quotequote all
Yes more than 2.1A will be fine. You need to make sure you get the correct DC plug on the end, monitors can have unusual DC connectors.

TonyRPH

13,554 posts

199 months

Tuesday 28th August 2018
quotequote all
megaphone said:
Yes more than 2.1A will be fine. You need to make sure you get the correct DC plug on the end, monitors can have unusual DC connectors.
Not only the correct plug, but the correct polarity.

Incorrect polarity will likely fry the monitor.


tenohfive

Original Poster:

6,276 posts

213 months

Tuesday 28th August 2018
quotequote all
Okay, how do I manage that ordering a power supply online - what needs to match?

This is the monitor:
https://www.necdisplay.com/p/ex231w-bk

SS2.

14,712 posts

269 months

Tuesday 28th August 2018
quotequote all
The original adapter for that monitor is an NEC ADP-40ED B.

Either buy one of those (~£20) or get a generic unit with the same spec, connector type and polarity as the original.



bristolracer

5,961 posts

180 months

Tuesday 28th August 2018
quotequote all
SS2. said:
The original adapter for that monitor is an NEC ADP-40ED B.

Either buy one of those (~£20) or get a generic unit with the same spec, connector type and polarity as the original.
May be worth tracking down the original nec part.
A lot of copy/generic power supplies are very cheaply made and often run very hot.