Hyundai i10 - Overheating warning
Hyundai i10 - Overheating warning
Author
Discussion

kiethton

Original Poster:

14,668 posts

211 months

Monday 25th March 2019
quotequote all
Some help if possible....

Parent's I10 - 2011, ~65k miles has started showing a red coolant warning

Strangely I took a look at the car yesterday - came on (from cold) within 1/2 mile and would always go off if you turned a corner but re-appear shortly afterward. Not looked to have lost any water and the oil cap is clear - due a service soon though looking at the colour.

Have done a little googling and can't see a likely cause - have instructed them to not drive it until I can get somebody to look at it - what do we think is the likely cause? - initial thoughts are a sensor/waterpump but wouldn't have thought it'd get hot enough within 1/2 mile?


E-bmw

13,615 posts

183 months

Monday 25th March 2019
quotequote all
Firstly check your manual, you say "red warning" is that level low or temperature high?

If it is coming on round corners you probably need to bleed the system & fill it back up, best done from cold.

Coilspring

577 posts

94 months

Monday 25th March 2019
quotequote all
Live data would help, to see what temperatures are being shown. Could be the temperature sensor, but could be an airlock as above, or a wiring issue affected by rubbing on something when cornering.

If it was mine without any data I would change the sensor 1st, see what happens then.

kiethton

Original Poster:

14,668 posts

211 months

Monday 25th March 2019
quotequote all
Thanks all - have left it with a tame mobile mechanic to take a look when he can - I couldn't see any leaks etc myself - system full and hasn't been disturbed recently (did 200 miles last week)

ETA 200 mile journey, not 20....

Edited by kiethton on Monday 25th March 17:16

GreenV8S

31,027 posts

315 months

Monday 25th March 2019
quotequote all
If you checked the coolant level, it can't be a true low coolant level fault. If it comes and goes within a few seconds it can't be a true overheating fault.

Given the behaviour you describe I'd be looking for a wiring/connection fault. I'd look at the connector to the low coolant sensor or temp sensor first, and then look for loom mechanical damage or heat damage. A wriggle test is a good way to locate intermittent problems like this.