Radiator mounting bolts

[Martin_MUC]

Good Afternoon
Looking at my Radiator mounts it seems the rubber has perished!!!
I can get the nut undone and the bit thats towards the engine out but are there any surprises with the other piece as I cannot see the nut - is it fixed in place?
There is approx 3,5 cm gap between the radiator mounting plate and the other end - is the part advertised on TVR Parts PN. K0467
TVR Radiator Mount long OE Radiator mount. 70mm end to end, rubber 30mm still going to fit - radiator is a Radtec.
Also will I need to remove the radiator or loosen it to allow the new mount to be installed?

thanks for any advice

[GT6k]

They are symmetrical the other ends stud is accessible through the headlamp hatch in the wheel arch I think.

[lancepar]

If you do ebay, just search car parts for "exhaust bobbin" plenty different types and sizes to chose from.

[Martin_MUC]

Thank you both for the replies - much appreciated.

[notaping]

My radiator looks like the same one as yours. I used TVR K0092

https://tvr-parts.com/tvr-parts/part-details/tvr-k...

Works fine.

[Byker28i]

Halfords do them for half the price of TVR parts HEX402
https://www.halfords.com/tools/garage-equipment/he...

Note that Hex403 is the rear exhaust hangers - also for £1.60

[Martin_MUC]

Thank you both for the tips.
Does the rubber fill the whole gap between the mount and body or can you adjust the position of the rad to suit?

[notaping]

No. I added a nut and washer at the back of the radiator mounting . . .

[Martin_MUC]

Great - thanks for that, a photo really helps.
Cheers