£640k health & safety fine for Nestle
Discussion
On the back of a guilty plea
Insignificant sum to them of course, but it serves as a warning that this stuff is serious
https://www.yorkpress.co.uk/news/19009189.nestle-u...
extract
"An investigation by the Health and Safety Executive (HSE) found the company had failed to prevent access to dangerous moving parts of the machine, namely an ‘in-running nip’. There was a gap large enough to allow access at a belt conveyor entry on the After Eight line.
Nestle UK Ltd, of City Place Gatwick, pleaded guilty to breaching Regulation 11 of the Provision and Use of Work Equipment Regulations 1998.They were fined £640,000 and ordered to pay £26,234 in costs."
Insignificant sum to them of course, but it serves as a warning that this stuff is serious
https://www.yorkpress.co.uk/news/19009189.nestle-u...
extract
"An investigation by the Health and Safety Executive (HSE) found the company had failed to prevent access to dangerous moving parts of the machine, namely an ‘in-running nip’. There was a gap large enough to allow access at a belt conveyor entry on the After Eight line.
Nestle UK Ltd, of City Place Gatwick, pleaded guilty to breaching Regulation 11 of the Provision and Use of Work Equipment Regulations 1998.They were fined £640,000 and ordered to pay £26,234 in costs."
surveyor said:
People mock health and safety, but not doing it does cost lives and life changing injuries.
Fully agree 
I worked for one company that was absolutely rabid about making sure everyone complied with their H&S policies. When I first started I thought they were being a bit OTT but I soon realised they weren't just paying lip service, they practiced what they preached.
One of their computer controlled machines had a control system that I had used before and had a reputation for doing random and un-commanded stuff so I was very wary of it. One afternoon the spindle started up of its own accord at maximum revs with the door open and none of the emergency stop buttons had any effect, I think I had to yank the isolator on the wall to shut it down in the end!
I reported the incident to the machine shop manager who just shrugged, took a form out of his desk, filled it in, told me to pull all the tools off the lathe and take the form it down to maintenance. The maintenance electrician read the form, asked me to show him the lathe, pulled out a screwdriver and disconnected the machine on the spot.
The lathe was off site within 36hrs.
That is Health and Safety should be done!
Gassing Station | News, Politics & Economics | Top of Page | What's New | My Stuff




