Best rear tyres for fast road use?
Discussion
LucyP said:
It depends what size tyres you are have. If they are the original sizes, then there is not much choice, and most are mainly budget tyres now. If you have changed the size, and you can get Michelin Pilot Sport 4S in the size you need, then they are the best.
I’m looking for 245 or 255/40R17Thanks
phazed said:
I have these on my porkchop, Brilliant tyres.
I would never replace just the rears. Put a full set on and feel confident!
Hello Peter.I would never replace just the rears. Put a full set on and feel confident!
So the 5.5 has made way for a boxter. Didn't see that one coming

Hi Andrew. The chimaera went as I needed an easier option at the time . that said, I really enjoy the Boxster.
Enough of that, can you not get the same tires as the front and keep her matched set? You may have said that they weren’t available and I’m too lazy to go back in the thread!
How’s the car going? Did you get everything you wanted finished in the end?
Enough of that, can you not get the same tires as the front and keep her matched set? You may have said that they weren’t available and I’m too lazy to go back in the thread!
How’s the car going? Did you get everything you wanted finished in the end?
They don’t make T1Rs any more or not in this size that I can find but I wanted to stay with Toyo to match the fronts hence buying the Sports.
The engine mods are pretty much done but still got an annoying tapping/knocking noise at tick over. Had a roller cam fitted by V8D a while back which is when it started but just can’t identify where this noise is coming from. Last attempt I had the cam and followers out and checked them over but couldn’t find anything wrong. I then meticulously set the preload on all the followers (hydraulic) but that didn’t cure it. So, bit of a head scratcher
. Apart from that it is epic.
The engine mods are pretty much done but still got an annoying tapping/knocking noise at tick over. Had a roller cam fitted by V8D a while back which is when it started but just can’t identify where this noise is coming from. Last attempt I had the cam and followers out and checked them over but couldn’t find anything wrong. I then meticulously set the preload on all the followers (hydraulic) but that didn’t cure it. So, bit of a head scratcher

Gassing Station | Cerbera | Top of Page | What's New | My Stuff