Possibly dumb bracelet screw pin question

[bigandclever]

I've managed to lose the screw-in pin that attaches the bracelet to my Steinhart ocean 1, while I was wearing it which seems to be some trick. How do I know what a suitable replacement will be? I feel like I should be concerned about getting the correct thread and whatnot.

I've not had an answer back from Steinhart yet, PH is usually quicker than any supplier anyway

[Barchettaman]

Eh? The spring bar that attaches the bracelet to the case?
Any watch shop will have one, or a Timpsons.
Steinhart normally take 22mm IIRC.

[bigandclever]

That's the point, it's not a spring bar. It's a screw-in. I assume I need to know the tap, diameter and length to get the right one .. maybe I'll just take the opposite end out and see if a Timpsons, or whoever, can match it up.

Edited by bigandclever on Wednesday 4th May 12:16

[Regbuser]

Bag of these, one will fit> https://www.amazon.co.uk/Qiterr-Repair-Accessories...
And a bit of blue loctite 242