Number plate adhesive

[Vipers]

Hi all, just been looking at adhesive stuff to refit a number plate, there is so much stuff on Amazon from individual pads to rolls of tape, but no point buying 10m of tape for one number plate.

So any recommendations please, I am pretty when the plate was fitted by the dealer it was a single strip the width of the plate, thanks everyone.

[CO2000]

Halfords or similar

[Court_S]

I just use whatever 3M tape I have in the garage and it’s worked ok so far.

It’s cheap enough on eBay / Amazon.

[pidsy]

2 small blobs of silicone sealant then making tape to hold it till it goes off.

Easy enough to remove the plate and the silicone rubs off the paintwork by hand.

[Vipers]

CheesecakeRunner said:

Mine are on with 3M 4943F tape. It’s the “Bonding at low temperatures” option here…

https://www.amazon.co.uk/gp/product/B00PRS1CWK

Good enough for me, thanks for the post, if it stuck you ones on, I will go with it, thanks to the other posts as well people.

[carlo996]

pidsy said:

2 small blobs of silicone sealant then making tape to hold it till it goes off.

Easy enough to remove the plate and the silicone rubs off the paintwork by hand.

This.

[Krikkit]

Vipers said:

CheesecakeRunner said:

Mine are on with 3M 4943F tape. It’s the “Bonding at low temperatures” option here…

https://www.amazon.co.uk/gp/product/B00PRS1CWK

Good enough for me, thanks for the post, if it stuck you ones on, I will go with it, thanks to the other posts as well people.

This is the best stuff, VHB.

Had a plate survive 140mph on the autobahn with two smallish strips.

[Vipers]

Krikkit said:

Vipers said:

CheesecakeRunner said:

Mine are on with 3M 4943F tape. It’s the “Bonding at low temperatures” option here…

https://www.amazon.co.uk/gp/product/B00PRS1CWK

Good enough for me, thanks for the post, if it stuck you ones on, I will go with it, thanks to the other posts as well people.

This is the best stuff, VHB.

Had a plate survive 140mph on the autobahn with two smallish strips.

In that case, mine will be safe as houses,

[oobster]

I read somewhere that the Velco Heavy Duty stuff is supposed to be good

https://www.amazon.co.uk/VELCRO-Brand-Superior-Hol...

[gamefreaks]

I've used the stickly back velcro for attaching number plates before.

It works a treat. You really have to pull hard to get them off again.

Clean the surfaces before you stick anything to it.

[dirky dirk]

I usually get some 3m tape off eBay
And clean both areas,
Then gently warm the plate stick it on warm it again over the cooker and leg it outside and put on the car

[Vipers]

Thank you everybody, all sorted.