Wheel Offsets

[BiggaJ]

I have been looking at some new wheels, fancy something from HRE or Vossen and quite like some of the Concaver designs. I would look to either stay on 19's or go for 20's ... the car is a 4.3 Vantage and I would like some advice on wheel offsets for the back and front so they sit more flush with the wings.

I have not played around with spacers so really have no idea what the offset would need to be, any advice is appreciated.

[Handyman2009]

I have a set of HRE P101 on my 2009 Vantage and I am running 19x9 ET40 front on 255/35R19 Continental Extreme Sport and 19x11 ET52 rear on 305/30R19 also on Continental Extreme Sport

[IainWhy]

the offset depends on the width of the rim. what width are you looking for.

I actually went for a smaller wheel in diameter but square and lower offset. 18x10 et38

2forge can drill and offset to your spec at standard pricing.

[milu]

I have Virage 20” on mine
245 and 295 widths.
Standard Virage in fact.
I do however run a 5 mm spacer in the front, just for looks.
The rears are 11.5 I believe
Can check the offset if required

[milu]

DBS wheels are 8.5” 42f
11” 54r

[BiggaJ]

IainWhy said:

the offset depends on the width of the rim. what width are you looking for.

I actually went for a smaller wheel in diameter but square and lower offset. 18x10 et38

2forge can drill and offset to your spec at standard pricing.

I'm looking at going 19" or 20" diameter, not quite decided on this yet. however, I think front will be 9" and back 10" or 10.5" but need advice on this also. Would like to stay with MP4S tyres where possible.

Really like the look of the Concaver CVR3 https://concaverwheels.com/cvr3 They do a range of sizes and would prefer the Titanium finish.

[Ryyy]

When buying alloys I've used https://willtheyfit.com/
To see how the new offset will compare to current

[AstonV]

Pistonheads has a good thread on this. Lots of good information on wheel widths and offsets.

https://www.6speedonline.com/forums/aston-martin/4...