Cleaning a deep fat fryer
Author
Discussion

silverfoxcc

Original Poster:

8,120 posts

168 months

Friday 23rd June 2023
quotequote all
Have a Russell Hobbs fryer that needs a good clean. everything comes apart. so the electrics do not need to be near water!!

Any suggestions on what i could use to get the congealed fat cleared that has got into all the nooks and crannies
The body is plastic, only metal parts, the bowl where the oil goes and the filter in the lid


I have tried using a steam cleaner, but that just seems to emulsify the goo, and also neat Fairy Liquid ( other brand are available) with a scourer ,again without much success.

Would oven cleaner do the trick if i left the bits overnight in one of their big bags, or would i end up with a mixture of plastic and cleaner at the bottom!



TIA

Spare tyre

12,056 posts

153 months

Friday 23rd June 2023
quotequote all
Brake cleaner?

Ussrcossack

906 posts

65 months

Friday 23rd June 2023
quotequote all
I'd look at a grease remover

It but a new one, air frier.

Mr Pointy

12,841 posts

182 months

Friday 23rd June 2023
quotequote all
Caustic soda or oven cleaner, although some on Mumsnet swear by a overnight soak with a couple of dishwaher tablets. Careful with aluminium though as I think it's attacked by too a long dip in caustic soda.

dudleybloke

20,553 posts

209 months

Friday 23rd June 2023
quotequote all
Elbow grease cleaner and degreaser is pretty good and safe to use on most things.

anonymous-user

77 months

Friday 23rd June 2023
quotequote all
dudleybloke said:
Elbow grease cleaner and degreaser is pretty good and safe to use on most things.
Agree, I use this to clean pretty much everything in the kitchen now, I have even been known to use it to clean door shuts/under bonnet on the shed.

Not sure how good it would be on this sort of thing though, I would imagine the grease has pretty much turned to rubber on some of the parts?

finlo

4,279 posts

226 months

Friday 23rd June 2023
quotequote all
Do what I do bin it and buy a new one annually, life's too short!

tomsugden

2,425 posts

251 months

Friday 23rd June 2023
quotequote all
^ this

I find they will come clean a few times in the dishwasher, then bin and start again. They're about £25 in Currys

https://www.currys.co.uk/products/logik-l30pfs12-p...

JuanCarlosFandango

9,557 posts

94 months

Friday 23rd June 2023
quotequote all
Heat it up to tip the old oil out then warm water and a bit of scrubbing usually does the trick. If you use lard or beef dripping instead of olive oil it is way easier to keep clean.

Mobile Chicane

21,821 posts

235 months

Friday 23rd June 2023
quotequote all
Oven cleaner and soak overnight.

Likewise, the basket. Unless you get every bit of grob off the basket, your food will taste of stale oil.

gotoPzero

20,010 posts

212 months

Friday 23rd June 2023
quotequote all
Rarely use mine these days but would normally strip it down and dish washer everything on a hot wash other than the element. So long as you washed it regularly it would always come out clean.

I bought a good quality one that is able to go in the dishwasher and has a removable element and control panel I forget the brand but its been pretty good. Even the outer case could go in the dish washer.

To clean the element I would spray it down with ethanol and wipe clean. Normally would take out 99% of the grease.

The only reason I stopped using it is it was a pain to set up (would use it outside) and getting rid of the old oil.

Wacky Racer

40,673 posts

270 months

Friday 23rd June 2023
quotequote all
A can of Gunk and a stiff brush.

blingybongy

4,079 posts

169 months

Saturday 24th June 2023
quotequote all
Having had to clean some pretty grim commercial deep fryers in the past I can attest to the efficacy of Nitromors.

Edited by blingybongy on Saturday 24th June 22:14

21TonyK

12,972 posts

232 months

Saturday 24th June 2023
quotequote all
Oven cleaner and a lot of chemicals will break the plastics down over time but more likely remove any transfers showing temps etc so be a bit wary. Boiling water, lots of it, is a safe option. As others have suggested a cheaper binned every few years is an answer.

If you feel inclined you can get commercial cleaners but probably not worth the cost or mess.

number2

5,030 posts

210 months

Sunday 25th June 2023
quotequote all
tomsugden said:
^ this

I find they will come clean a few times in the dishwasher, then bin and start again. They're about £25 in Currys

https://www.currys.co.uk/products/logik-l30pfs12-p...
That's crazy cheap!

I was going to suggest this https://www.argos.co.uk/product/8187633 really good system to filter and reuse the oil, and its component parts all go in the dishwasher.

Quite a price difference though.

ChevronB19

8,522 posts

186 months

Monday 26th June 2023
quotequote all
tomsugden said:
^ this

I find they will come clean a few times in the dishwasher, then bin and start again. They're about £25 in Currys

https://www.currys.co.uk/products/logik-l30pfs12-p...
That’s the one I have, it’s really good if you are after something basic.

21TonyK

12,972 posts

232 months

Monday 26th June 2023
quotequote all
ChevronB19 said:
tomsugden said:
^ this

I find they will come clean a few times in the dishwasher, then bin and start again. They're about £25 in Currys

https://www.currys.co.uk/products/logik-l30pfs12-p...
That’s the one I have, it’s really good if you are after something basic.
Every third Xmas M-I-L buys me a new one. Old one goes to the tip.