Issues with 2007 Toyota Aygo

[trueblue85]

So my Aygo 2007 plate has started playing up, once engine has started I have the abs and p/s lights flashing no pattern to it, and then when I start driving the lights go out, however when pulling up to traffic lights or stopping the lights start blinking again, then once get going again they switch off. Also when applying the clutch down the car starts making a rumbling sound anyone have any ideas what issue maybe?

[PositronicRay]

trueblue85 said:

So my Aygo 2007 plate has started playing up, once engine has started I have the abs and p/s lights flashing no pattern to it, and then when I start driving the lights go out, however when pulling up to traffic lights or stopping the lights start blinking again, then once get going again they switch off. Also when applying the clutch down the car starts making a rumbling sound anyone have any ideas what issue maybe?

The lights may be down to a weak battery. Clutch sounds liie a release bearing.

[E-bmw]

PositronicRay said:

trueblue85 said:

So my Aygo 2007 plate has started playing up, once engine has started I have the abs and p/s lights flashing no pattern to it, and then when I start driving the lights go out, however when pulling up to traffic lights or stopping the lights start blinking again, then once get going again they switch off. Also when applying the clutch down the car starts making a rumbling sound anyone have any ideas what issue maybe?

The lights may be down to a weak battery. Clutch sounds liie a release bearing.

^^^ Wot 'e said.

A code reader may help to check for any resident issues aside of these obvious starting points.

[Scrump]

My daughter’s 107 (same car as your Aygo) had the same issue with those warning lights,
I did read that it may be due to a dry solder joint in the Power Steering ecu, so I removed that ecu to check.
I opened the ecu but couldn’t see any dry joints so just refitted it- to find that the lights had gone away and the car was okay again. I can only think that it was a bad connection on the multi pin plug into the ECU.

The power steering ecu is located behind the dashboard to the right of the steering wheel (on a rhd car). Very fiddly to remove and refit without refitting the dash (but it is possible).