Concrete garage floor has pot holes
Concrete garage floor has pot holes
Author
Discussion

LaserTam

Original Poster:

2,183 posts

250 months

Tuesday 8th April 2025
quotequote all
1950s garage floor, has a few areas where the concrete has crumbled, leaving some pot holes. What would be the best method to repair these? Garage is fairly full of stuff so any repair will need to be just that and not a completely relaid floor.

JoshSm

5,476 posts

68 months

Tuesday 8th April 2025
quotequote all
Epoxy repair mortar? There's a whole world of epoxy concrete repair products for exactly this sort of job.

OutInTheShed

14,940 posts

57 months

Tuesday 8th April 2025
quotequote all
I would suspect the concrete is a bit 'not very good' and will want replacing before too long, so I'd be reluctant to spend proper money on patching it up.

I'd consider using an exterior sealer/primer then making good with mortar.

MajorMantra

1,717 posts

143 months

Tuesday 8th April 2025
quotequote all
Probably the 'wrong' method, but it would be pretty easy to slosh some renovation screed (levelling compound with some strength) into the holes, assuming they're not too deep. Different compounds will do different depths, so check first.

LaserTam

Original Poster:

2,183 posts

250 months

Wednesday 9th April 2025
quotequote all
OutInTheShed said:
I would suspect the concrete is a bit 'not very good' and will want replacing before too long, so I'd be reluctant to spend proper money on patching it up.

I'd consider using an exterior sealer/primer then making good with mortar.
I suspect it's been as it is for many many years, based purely on the apparent lack of up-keep in the rest of property, and the previous elderly owner wouldn't have used the garage much. But thanks for the advice.

119

20,104 posts

67 months

Wednesday 9th April 2025
quotequote all
Had a similar issue many years ago with bare concrete floor.

Gave it a good brushing, filled holes with ready mix screed and used proper garage floor paint to seal it.

Never had the problem again!

T1547

1,247 posts

165 months

Thursday 10th April 2025
quotequote all
Concrete repair mortar is what you need, either in fluid or trowel-applied form.

Remove all the loose/crumbling areas, dampen the surface with water so it soaks into the existing concrete (no standing water), then simply pour in a product like this https://lilleytileandstone.co.uk/mapei-mapegrout-s... . Allow to cure then job done.