Know anything about electronics?
Discussion
Following on from the whirring water valve control motor - tightening up the mounting did the trick but noticed loose wire on back of fresh air flap valve motor, soldered it on but only worked once then never again. My question is to those who understand these elcectronic gizmo's. On the back of the motor there is a black disk about 1cm dia. with 3 wires (blue, green & white) it has 10K & 114 printed on the side. What is this thing??? I think I may have bu@@ered it up when soldering the loose wire on. Any help much appreciated.
David
David
Gassing Station | Chimaera | Top of Page | What's New | My Stuff